2. Energy Suspension
  3. 3.2105G3.2105G

Energy Suspension 3.2105G3.2105G Operating instructions

  • Hello! I've reviewed the instruction sheet for Energy Suspension shackle bushings 2008, 2007 and 2006, focusing on the removal of factory bushings and installation of the polyurethane replacement parts. The document highlights that the factory bushings may be stuck due to corrosion, and that the main eye bushings also require pressing out.
  • What does the instruction sheet describe?
    What if I am not familiar with this type of work?
    What is recommended before performing any work on my vehicle?
    What is the difference in removal of shackle end and main eye bushings?
17010
Updated 04/02/03 APP
INSTRUCTION SHEET FOR SET #3.2105
Read this instruction sheet thoroughly before initiating any work!
4 - Part # 2008 Frame casting shackle eye
4 - Part # 2007 Spring eye shackle end
4 - Part # 2006 Main eye
Original Equipment rubber bushing removal:
The shackle end bushings (small end) including frame
shackle are not pressed but may be stuck as a result of
corrosion. They may require a little coaxing. The main eye
rubber bushing is encased in an outer metal sleeve that will
require pressing out.
1131 VIA CALLEJON, SAN CLEMENTE, CA 92673
R
2006
2007
2008
Note: It is recommended that this set be professionally installed if you are unfamiliar with this
type of work, and a factory service manual be purchased prior to performing any work on your
vehicle for proper disassembly, reassembly and torque specs. These instructions are intended for
bushing removal and install of Energy Suspension polyurethane bushings, once you have
removed the factory component from your vehicle. Updated 13/DEC/01 BRH
2003 Energy Suspension. All rights reserved.2003 Energy Suspension. All rights reserved.
CC
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
17010
Updated 04/02/03 APP
INSTRUCTION SHEET FOR SET #3.2105
Read this instruction sheet thoroughly before initiating any work!
4 - Part # 2008 Frame casting shackle eye
4 - Part # 2007 Spring eye shackle end
4 - Part # 2006 Main eye
Original Equipment rubber bushing removal:
The shackle end bushings (small end) including frame
shackle are not pressed but may be stuck as a result of
corrosion. They may require a little coaxing. The main eye
rubber bushing is encased in an outer metal sleeve that will
require pressing out.
1131 VIA CALLEJON, SAN CLEMENTE, CA 92673
R
2006
2007
2008
Note: It is recommended that this set be professionally installed if you are unfamiliar with this
type of work, and a factory service manual be purchased prior to performing any work on your
vehicle for proper disassembly, reassembly and torque specs. These instructions are intended for
bushing removal and install of Energy Suspension polyurethane bushings, once you have
removed the factory component from your vehicle. Updated 13/DEC/01 BRH
2003 Energy Suspension. All rights reserved.2003 Energy Suspension. All rights reserved.
CC
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
/