Customer Service 1-800-633-5096
For assistance with assembly contact:
Max Load:
SEI ITEM NO HZ1027
Assembly Instructions
WALL-MOUNT PERSONAL ORGANIZER
www.seidal.com
Southern Enterprises, Inc.
service@seidal.com
Call Customer Service at 1-800-633-5096
For replacement parts or questions, please
manufacturer for assistance, questions or
Do not return product to store, please call
No.2 Phillips Screwdriver
CABINET
SCREWS
parts.
the finish. Avoid rubbing or scratching the
Assembly Tool Required
surface with rough or abrasive objects.
Periodically apply furniture wax to renew
Before using, wipe with a clean, dry cloth.
Care and Cleaning Instructions:
ANCHOR
to be hung on wall stud for more security and stability.
2/7"drill bit, 24"level, and a tape measure. Unit needs
Suggested tools: Phillip head screw driver, power drill,
of 2
Quantity
WALL-MOUNT PERSONAL ORGANIZER
Please review all parts and hardware before disposing of any packaging.
hardware with your unit.
the screw diagrams below. You may receive extra
Using a screw that is too long will cause damage.
Before beginning assembly, separate each type of screw. Carefully study
Call Customer Service if missing hardware. Do not return to store/retailer.
A (1)
Parts List
of 2
Quantity
(2)
Eye Level
Figure 2
into wall
Drill two 2/7"holes
2-1/4"
Figure 1
at the mounting hole marks.
drill two 2/7"holes through the wallboard
Using the power drill and 2/7"drill bit,
marks are level on the wall.
Using the level, make sure that all two
mounting holes. See Figure 2.
Measure the wall and mark the location of
the center of each of the two screw
23-5/8"
12"
16-9/16"
Measure the wall and mark the personal
organizer width and height. See Figure 1.
floor, normally eye level.
Locate the personal organizer on a solid
29-1/8"
surface like carpet or blanket.
assembling.
Wood may scratch easily. Be careful when
Unpack and lay parts on clean, padded
Assembly Instructions:
wall and at a comfortable height off the
WALL-MOUNT PERSONAL ORGANIZER
Assembly Instructions
It may be necessary to use a small
personal organizer is when the top edge of
(1, Figure 4) onto the two mounting screws
Figure 4
and down).
level and vertically plumb (straight up
the personal organizer is horizontally
NOTICE
Using the level, check to make sure that
3
1/4"Gap
Figure 3
head of screw and the wall surface.
until there is a gap of 1/4"between the
anchors. See Figure 3. Turn the screw in
install one screw into each of the
Using the phillip head screwdriver,
Install the personal organizer
(3, Figure 4).
securely on the mounting screw
each of the mounting holes is resting
The proper and secure mounting of the
using the mounting holes (2, Figure 4).
2
1
2/7"Hole
place.
hammer to gently tap the anchor into
NOTE:
with the wall.
Make sure that the wall anchor is flush
See Figure 3.
anchors into each of the two 2/7"holes.
Insert one of the furnished plastic
NOTICE
wiring or plumbing pipes.
Screws
Anchor
Make sure not to drill into electrical
SEI ITEM NO HZ1027
PARTS REPLACEMENT FORM
Parts Letter
Please indicate color/size/style number:
Please indicate where you purchased this item:Store/Website/Catalog
Missing or damaged hardware and/or parts will be replaced free
of charge. We do not sell parts. Southern Enterprises Inc.
will provide replacement parts for only those items purchased
within the last 9 months. If this product has not been
purchased from our retail affiliates (within 9 months), we are
under no obligation to provide parts or replacement
merchandise. Parts will not be available for items arriving
fully assembled. Parts will be sent if available from SEI
Style No
Customer Information
City/State/Zip Code
Address
Name
Phone Number
Parts Description Quantity Needed
Coppell, TX 75019
servic[email protected]
Customer Service 1-800-633-5096
600 Freeport Pkwy, Ste: 200
/