Southern Enterprises Talus MS040800TX Assembly & Instruction Manual

Page |

1

PO#:

MS040800TX

Talus Media Console

Assembly Instructions

For assistance with assembly, contact:

Southern Enterprises, Inc.

Customer Service: 1-800-633-5096

[email protected]om

www.sei

furniturestore

.com

Page |

2

1) Quantity

of 1

Top

2) Quantity

of 4

Support

3) Quantity

of 1

Middle Panel

4L) Quantity

of 1

Left Side Panel

4R) Quantity

of 1

Right Side Panel

5L) Quantity

of 1

Left Middle Clapboard

5R) Quantity

of 1

Right Middle Clapboard

6) Quantity

of 1

Bottom Panel

7R) Quantity

of 1

Left Door Panel

7L) Quantity

of 1

Right Door Panel

8) Quantity

of 2

Side Adjustable Shelf

9) Quantity

of 1

Middle Adjustable Shelf

Talus Media Console

Parts List

Please check packaging for all parts and hardware before discarding. Before beginning assembly, separate each

type of hardware. Carefully study the diagrams below and check that you have all parts indicated.

Call Customer Service if missing any hardware. Using the incorrect hardware will cause damage.

Page |

3

10) Quantity

of 4

Leg

11) Quantity

of 1

Adjustable Leg

12) Quantity

of 1

Back Panel

A) Quantity

of 16

Cam Bolts

B) Quantity

of 28

Wood Dowels

Dia. 5/16"x1-1/4

C) Quantity

of 16

Cam Locks

D) Quantity

of 16

Cotton Mat

E) Quantity

of 8

Screw Dia.3*10

F) Quantity

of 4

Bolts

Dia. 5/32"x5/8"

G) Quantity

o

f 2

Knob

H) Quantity

o

f 2

Screw Dia.3*10

I) Quantity

o

f 4

Bolts Dia.1/4” x1-3/8”

J) Quantity

of 4

Bolts Dia.1/4”*3-1/2” x1-3/8”

L

)

Quantity

of 8

Flat Washer Dia. 1/4”*14

M) Quantity

of 8

Spring Washer Dia. 1/4”

N) Quantity

of 1

Allen Wrench

O) Quantity

of 2

Magnet

PL)

Quantity

of 2

Page |

4

PR) Quantity

of 2

Q) Quantity

of 2

Cam Locks

R) Quantity

of 26

Screw Dia.3*14

S) Quantity

of 4

Bolts Dia. 3*x 14

T) Quantity

of 12

Shelf Pin

U) Quantity

of 4

Screw Dia.1/8”*5/8L”

V) Quantity

of 4

Bracket

W)

Quantity

of 2

Plastic chain

X) Quantity

of 4

Anchor

Y) Quantity

of 4

Screw Dia1/8”x1-3/8”L

Care and Cleaning Instructions:

Before using, wipe with a clean, dry cloth.

Periodically apply furniture wax to renew the

finish. Avoid rubbing or scratching the surface

with rough or abrasive objects.

For replacement parts or questions, please call

SEI Customer Service at 1-800-633-5096.

Assembly Tool Required:

No.2 Phillips Screwdriver, Hammer

(Not Included)

Page |

5

Figure 1

Insert Cam Locks (C) into

corresponding holes on Supports

(2).

Screw Cam Bolts (A) into threaded

holes on Top Panel (1).

Attach Supports (2) to Top Panel

(1) by inserting Cam Bolts (A) and

Wood Dowels (B) into

corresponding holes until all

panels meet.

Tighten Cam Bolts (A) by rotating

Cam Locks (C) clockwise using

Phillips screwdriver (not included).

Cover cam lock holes with Covers

(D).

Figure 2

Attach Middle Panel (3) to

pre-assembled unit from Figure 1

with Bolts (I), Spring Washers (M),

and Flat Washers (L).

Tighten Bolts (I) with Allen Wrench

(N).

Talus Media Console

Assembly Instructions

C

B

Page |

6

Figure 3

Attach Magnets (O) to

pre-assembled unit from Figure 2

with Screws (S).

Tighten Screws (S) with Phillips

screwdriver (not included)

Figure 4

Insert Cam Locks (C) into

corresponding holes on Panels

(4L/4R/5L/5R).

Screw Cam Bolts (A) into threaded

holes on pre-assembled unit from

Figure 3.

Attach Panels (4L/4R/5L/5R) to

pre-assembled unit from Figure 3

by inserting Cam Bolts (A) and

Wood Dowels (B) into

corresponding holes until all

panels meet.

Tighten Cam Bolts (A) by rotating

Cam Locks (B) clockwise using

Phillips screwdriver (not included).

Page |

7

Figure 5

Attach Hinges (PL/PR) to Left

Door Panel (7L) with Screws (E).

Attach Iron Plate (Q) to left Door

Panel (7L) with Screw (H).

Attach Handle (G) to Left Door

Panel (7L) with Bolts (F).

Tighten Bolts (F) and Screws

(E/H) with Phillips screwdriver (not

included).

Figure 6

Attach Hinges (PL/PR) to Right

Door Panel (7R) with Screws (E).

Attach Iron Plate (Q) to Right Door

Panel (7R) with Screw (H).

Attach Handle (G) to Right Door

Panel (7R) with Bolts (F).

Tighten Bolts (F) and Screws

(E/H) with Phillips screwdriver (not

included).

PR

Q

PL

Q

PR

Page |

8

Figure 7

Insert Cam Locks (C) into

corresponding holes on

pre-assembled unit from Figure 4.

Screw Cam Bolts (A) into threaded

holes on Bottom Panel (6).

Attach Doors (7L/7R) to

pre-assembled unit from Figure 4

by inserting upper hinges into

corresponding holes. Lower

hinges will fit into holed on Bottom

Panel (6)

Attach Bottom Panel (6) to

pre-assembled unit from Figure 4

by inserting Cam Bolts (A) and

Wood Dowels (B) into

corresponding holes until all

panels meet.

Tighten Cam Bolts (A) by rotating

Cam Locks (B) clockwise using

Phillips screwdriver (not included).

Figure 8

Attach Legs (10) to pre-assembled

unit from Figure 7 with Bolts (J),

Spring Washers (M), and Flat

Washers (L).

Tighten Bolts (J) with Allen

Wrench (N).

Attach Middle Leg (11) to

pre-assembled unit from Figure 7

by hand.

A

Page |

9

Figure 9

Flip over pre-assembled unit from

Figure 8 so that the unit is resting

on its legs.

Attach Back Panel (12) to

pre-assembled unit from Figure 8

with Screws (R).

Tighten Screws (R) with Phillips

screwdriver (not included).

Figure 10

Insert Shelf Pins (T) into desired

pre-drilled holes on pre-assembled

unit from Figure 9.

Place Shelf Panels (8/9) on Shelf

Pins (T).

T

Page |

10

Figure 11

Attach Brackets (V) to back of

pre-assembled unit from Figure 10

using Screws (U).

Tighten Screws (U) using Philips

screwdriver (not included).

Mark two desired locations on

wall.

Drill two 3/16" holes on wall.

Insert Plastic Anchors (X) into the

2 holes on wall, tap with hammer

(not included) as needed

Attach Brackets (V) to wall using

Screws (Y).

Tighten Screws (Y) using Philips

screwdriver (not included).

Figure 12

Move this item close to the wall.

Tie Brackets (V) together with

Plastic Chains (W).

Anti-tipping hardware must be

used for this product to avoid

tipping and injury.

Now you Talus Media Console is

ready for use!

WALL

Page |

11

Customer Information

Name

Address

City/State/Zip Code

Phone Number

Please indicate where you purchased this item: Store/Website/Catalog

Please indicate color/size/style number:

Style No Parts Letter Parts Description Quantity Needed

Please immediately examine this product carefully. Any request for missing parts or damage replacement must be

received within 90 days of your receipt of the product. Replacement, if available, will be honored within this time

frame. Parts will not be available for items arriving fully assembled. We do not recommend modifying product(s)

and we are not responsible for any damages due to product modification(s). If damages or missing parts are not

reported within 90 days of your receipt, we are under no obligation to provide parts or replacement merchandise.

For product issues, please contact Southern Enterprises at 800-633-5096 (toll-free) / 972-869-0111 (Dallas),

Mon-Fri 9am – 4pm CST, or email us at service@seidal.com. Please ask for customer service representative for

issues involving damages or replacement parts. Please ask for technical assistance representative for any issues

with product and assembly/construction.

Please contact the retailer that you purchased from for returns.

Parts Replacement Form

Customer Service: 1-800-633-5096

[email protected]

Southern Enterprises, Inc.

600 Freeport Parkway, Suite 200

Coppell, Texas 75019

Page |

12

CAUTION

The top shelf is intended for a flat screen television with a maximum overall width of 46” and

supports up to 85 lb.

The top shelf is NOT INTENDED for tube televisions.

Each VCR shelf should not be loaded with more than 20 lb

Each middle shelf should not be loaded with more than 20 lb

Each side shelf should not be loaded with more than 15 lb.

DO NOT EXCEED RECOMMENDED LOAD.

Use with products heavier than the maximum sizes and weights indicated may result in

instability, causing possible injury.

This unit contains a permanent warning sticker located on under side of top shelf or inside

drawer.

Do not allow children under 16 years to move the media console.

Model: MS040800TX

Talus Media Console

Southern Enterprises, Inc

600 Freeport Parkway,

Suite 200 Coppell, Texas, 75019

Manufacture Date: 11/28/2015

Southern Enterprises Talus MS040800TX Assembly & Instruction Manual

Southern Enterprises Talus MS040800TX Assembly & Instruction Manual

Related papers

Other documents