2. George Kovacs
  3. P1781-044B-L

George Kovacs P1781-044B-L, P1781-719-L User manual

  • Hello! I am an AI chatbot trained to assist you with the George Kovacs P1781-044B-L User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
INSTALLATION INSTRUCTIONS
FOR P1781-719-L/ P1781-044B-L
FOR LED Pendant Light
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKE R.
AV E R T I SS E ME N T ! C O U P E R LE C O U R A N T A U N I V E A U D E S F US IB L E S OU D O D I S J O N CT E UR
Page: 1/1
Fig. 2
PREPARING FOR INSTALLATION (Fig. 1)
1. Shut off power at the fuse box or circuit breaker box and
remove the old fixture including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts in
a clear area. Take care not to misplace any small parts
necessary for installation.
SUGGESTED INSTALLATION (Fig. 1)
3. Secure the thread rod (I) to the hex nut (J).
4. Put the cover (H) onto the fixture body (D) through the
thread rod (I), and secure it by the nut (G).
5. Remove the two mounting screws (DD) from the side of the
canopy (A) and remove the mounting plate (BB).
6. Press the wire restraint (B) on the canopy (A) to adjust the
cable (C) to desired length. Press the wire restraint (F) on
the canopy (A) to adjust the fixture wire (E). The fixture wire
(E) should be longer than the cable (C).
7. Secure the mounting plate (BB) to the outlet box (not
included) with the outlet box screws (CC). Tighten until snug.
CONNECTING THE WIRES (Fig. 2)
8. Connect the electrical wires as shown in Fig. 2, making sure
that all wire connectors are secured. If your outlet has a
ground wire (green or bare copper), connect the fixture’s
ground wire to it. Otherwise, connect the fixture’s ground
wire directly to the mounting plate (BB) using the green
screw (AA) provided. Tuck the wire connections neatly into
the junction box.
COMPLETING THE INSTALLATION (Fig. 1)
9. Attach the canopy (A) to the mounting plate (BB) and secure
it with the mounting screws (DD).
Your installation is now complete. Return power to the
junction box and test the fixture.
IMPORTANT: Fixture should be installed by a qualified electrician to
ensure proper wiring and installation.
Dimmable with ELV and/or LED compatible wall dimmer switches.
.
Fig.1
set#A-021-145
- Mounting plate
- Ground screw
- Mounting screws*2pcs
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green
(Ground)
/