2. Minka Group
  3. 6201-44

Minka Group 6201-44, 6201-66A, 6201-84 User manual

  • Hello! I've reviewed the installation instructions for the Minka Group light fixture models 6201-44, 6201-66A, and 6201-84. This document provides detailed guidance on how to safely mount and wire your new fixture, including adjusting the wire length and installing the bulb. I'm ready to answer any questions you have about the installation process or the specifics mentioned in this manual.
  • What should I do before starting the installation?
    What is the size of the outlet box screws?
    How do I adjust the wire length?
    What kind of light bulb should I use?
    What is the recommended way to deal with the cord if it is not straight?
B
A
CD
F
E
G
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Green or
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
INSTALLATION INSTRUCTIONS
Item#6201-44/66A/84 (New. 01/05/2023)
READ AND SAVE THESE INSTRUCTIONS
W A R N I N G ! S H U T P O W E R O F F AT F U S E O R C I R C U I T B R E A K E R .
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
1.
Fig. 1
Fig. 2
MOUNTING THE FIXTURE (Fig.1)
1.
hardware.
2. Carefully unpack your new fixture and l
ay out all the
small parts necessary for installation.
3. Attach the mounting plate (B) to outlet box (
not
included) using outlet box screws (C) (SIZE: #8-
32N,
L0.5"). The side of the mounting plate (B) ma
rked
"GND" must face out.
4. Adjust
wire to desired hanging length using the small
screw located on
side of wire grip (F) with a flathead
screwdriver (not included). Ensure to re-tighten
set
screw after wire adjustment. To straighten c
ord,
please use a blow dryer (not included) if necessary.
5. Remove any excess wire leaving approximately 7
"
beyond canopy (E) for wire connections.
CONNECTING THE WIRES (Fig.2)
6. C
onnect the electrical wires as shown in Fig.2,
making sure that all wire connectors (A
) are secured.
I
f your outlet box has a ground wire (green or bare
copper), connect the fixture’
s ground wire to it.
Otherwise, connect fixture’
s ground wire directly to
mounting plate (B) using green screw provided.
7. Tuck wire connections neatly into the outlet box.
FINISHING THE INSTALLATION (Fig.1)
8.
secure with screws (D).
9. Install (1) one medium base (E26) bulb (G
) up to 60
watts each or CFL or LED equivalent (not inclu
ded)
in accordance with the fixture specification—
DO
NOT
EXCEED THE MAXIMUM WATTAGE
NOMINALE MAXIMALE!).
Your installation is now complete. Return power and
test the fixture.
6201-44/66A/84
Note: Illustration (Fig.1) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased.
Set# A-022-115
-Mounting Plate
-Ground Screw
-Mounting Screw *2
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY
A QUALIFIED ELECTRICIAN TO ENSURE PROPER
WIRING AND INSTALLATION.
/