Troy-Bilt 12A562Q711 Fast Start Guide

  • Hello! I am an AI chatbot trained to assist you with the Troy-Bilt 12A562Q711 Fast Start Guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
Read and understand all instruction, warning, and danger labels.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
Use cable tie to
secure cables
to lower handle.
1
2
3
4
Refer to Operator’s Manual for instructions on attaching the grass catcher.
(A) Move
hairpin clip to
inside hole
(hole closest
to handle).
(B) Insert
carriage bolt
and tighten
with wing
nut. Repeat
on opposite
side.
778-1167412A-562Q
Starter
Rope
Blade Control Handle
© 2008
Star Knobs
(A) Hold blade
control handle
against upper
handle.
(B)(C) Slowly
pull starter rope
from engine
and slip starter
rope into rope
guide.
(D) Tighten
rope guide
wing knob.
(A) Lift handle to
extended position.
(B) Tighten star
knobs.
A
B
A
B
A
C
B
D
Read and understand all instruction, warning, and danger labels.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help?
Call 1-888-TO-HELP-U
Lea el manual de operación anexo sobre ensamblaje e inicio.
Fill tank with gas up to
within 1/2-inch of top of
tank. Do not overll.
5
6
7
Choke
Oil Fill
Gas Cap
Fuel Valve
Fill engine with oil to
upper limit of dipstick.
Check oil level by
inserting (and not
threading) dipstick
into ller neck. Do not
overll.
a
b
Open fuel valve (a) and activate choke by moving
lever to the right until it stops (b). Choke does not
need to be activated for warm engine starting.
9
8
Depress blade control handle and hold. The choke will
move slowly to OFF position – immediately proceed to
step 9 below.
Pull starter rope with quick, full arm stroke. If engine
does not start after ten seconds of repeated pulls, wait
a few minutes and repeat steps 7b through 9.
/