2. Cell2
  3. 86-M4310-0011.0
86-M4310-0011.0

Cell2 86-M4310-0011.0 User manual

  • Hello! I am an AI chatbot trained to assist you with the Cell2 86-M4310-0011.0 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
86-M4310-0011.0
To +VDC (fuse @ 1A):....WHITE
To Chassis Ground:.......BLACK
For Synchronization and
Flash Pattern:................BROWN
For Flash Pattern, momentarily
apply+VDC to BROWN wire:
• once for next pattern
• quick three times to reset to FP#1
(see flash pattern chart)
Surface Mount
NOTE: This unit may not be factory-set
at FP#1.
1 Random
2 Steady
3 Single (SAE) (CA13)
4 Mega
5 Double (SAE)
6 Triple (SAE)
7 Quad (SAE)
8 Quint (SAE)
9 8 Flash (SAE)
10 Single-Quad
11 Single H/L
12 Single-Triple-Quint
Flash Patterns
FP#
7
7
.
3
mm (3
.
04
”)
For Synchronization:
Connect BROWN wires of all heads together for synchronization
(All heads should be set at the same Flash Pattern)
For Simultaneous or Alternating Flash:
1. Apply +VDC WHITE and BROWN wires simultaneously to enter Grouping mode; lighthead
will display short (single or double) flashes:
• Single flash = Group1 • Double flash = Group2
2. Remove BROWN wire from +VDC and momentarily apply to +VDC to change Groups:
• Heads in the same Group flash together.
• Group1 Heads alternate with Group2 heads.
Overtightening the mounting screws could damage the lighthead and void the warranty.
Use an in-lb torque wrench, tighten the mounting screws with the suggested range of torque value:
For #6 mounting screws - 6 to 7.8 in-lbs.
CAUTION
/