2. Cell2
  3. LP4 LED PAD
LP4 LED PAD

Cell2 LP4 LED PAD User manual

  • Hello! I've reviewed the LP4 LED Pad user manual and I'm here to help with your questions. This document covers how to connect the LED pad, manage group synchronization, and adjust flash patterns using the brown wire. I can assist with details regarding specific flash patterns, group settings, and mounting instructions if you have any questions.
  • How do I enter the grouping mode?
    How do I change groups for alternating flash?
    How do I change flash patterns?
150812M65
To +VDC (fuse @ 1A).....
To Chassis Ground..........
For Synchronization:.......
Connect BROWN wires of all heads together
for synchronization
(All heads should be set to the same pattern)
For Simultaneous or Alternating Flash:
1. Apply +VDC to WHITE and BROWN wires simultaneously to enter
Grouping mode; lighthead will display short (single or double) flashes:
� Single flash = Group1 � Double flash = Group2
2. Remove BROWN wire from +VDC and momentarily apply to +VDC to
change Groups:
� Heads in the same Group flash together.
� Group1 Heads alternate with Group2 Heaads.
WHITE
BLACK
BROWN
For Flash Patterns:
Momentarily apply +VDC to
BROWN wire:
� once for next pattern
� quick three times to reset
to FP#1
NOTE: This unit may not be
factory set at FP#1.
NOTE: To obtain optimum adhesion,
the surfaces must be clean, dry and
well unified.
FP#
1 Single (2Hz)
2 Double (2Hz)
3 Triple (2Hz)
5 Random
4 Quad (2Hz)
6 Single (split)
7 Double (split)
8 Quad (split)
9 Quint (split)
10 Mega (split)
11 Ultra (split)
12 Single-Quad (split)
13 Single H/L (split)
14 Single (all) (SAE)
15 Double (all) (SAE)
16 Quad (all) (SAE)
17 Quint (all) (SAE)
18 Mega (all)
19 Ultra (all) (SAE)
20 Single-Quad (all)
21 Single H/L (all)
22 Steady Half
23 Steady All
Flash Patterns
*SPLIT = Left alternating Right *ALL=Simultaneous
4.02"(102mm)
LP4 LED PAD UserManual
Surface Mount
/