SURFACE CUT-OUT AREA
User Access
Page size: 8½" x 11"
Print scale 1:1
Do not shrink.
1. Confirm the product to be installed.
2. Before printing, double-check the
print settings and make sure the page
is not scaled.
3. Print the template.
4. Cut along the red line to remove the surface
cut-out area (gray) from the template.
5. Measure the cutout and template.
6. Mark the position on the mounting surface
where the TLP Pro 525C is being installed.
7. Double check dimensions and position,
then cut the opening.
0.00" (0.00 mm)
0.02" (0.51 mm)
+
User Access
Trim Ring
Outer Edge
(Do not cut
this line.)
68-3393-01 Rev. A
Cut-Out Template for the Extron
TLP Pro 525C
6.00"
(152 mm)
7.50"
(191 mm)
R = 0.25"
(6.4 mm)
