Cut-Out Template for the Extron
TLP Pro 720C
1. Confirm the product to be installed.
2. Before printing, double-check the
print settings and make sure the page
is not scaled.
3. Remove the surface cut-out area (gray)
from the template.
4. Measure the cutout and template.
5. Mark the position on the mounting surface
where the TLP Pro 720C is being installed.
6. Double check dimensions and position,
then cut the opening.
68-2179-02 Rev. A
Trim Ring Outer Edge
(Do not cut this line.)
Page size: 11" x 17"
Print scale 1:1
Do not shrink.
User Access
PC
LAPTOP
DVD
DOC CAM
AUXILIARY
DISPLAY ON
DISPLAY OFF
AUTO IMAGE
VOLUME
VOLUME
Extron
User Access
R = 0.25" (6.35 mm)
7.10"
(18.03 cm)
8.90"
(22.61 cm)
+ 0.00" (0.00 cm)
- 0.02" (0.05 cm)
SURFACE
CUT-OUT
AREA
Trim Ring Lip
Width = 0.325" (8.26 mm)
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Extron TLP Pro 720C User manual
-
-
-
-
Extron TLP Pro 320C Template
-
Extron TLP Pro 525C Template
-
Extron Hideaway HSA 300 Template
-
-
-
Extron electronics TLE 350 User manual