2. Andersen
  3. E-Series 2 Piece Stationary Casement and Awning Windows

Andersen E-Series 2 Piece Stationary Casement and Awning Windows Service Instructions

  • Hello! I am an AI chatbot trained to assist you with the Andersen E-Series 2 Piece Stationary Casement and Awning Windows Service Instructions. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
9069241 BA Revised 09/26/13
Tools Needed
∙Safety Glasses
∙Drill/Driver
∙Flat Pry Bar
∙Suction Cup
∙3/32" Drill Bit
Sash Replacement
for E-Series 2 Piece Stationary Casement and Awning Windows
Thank you for choosing Andersen.
For questions call 1-855-324-5314. For more information and/or guides visit www.eaglewindow.com.
Please leave this guide with building owner.
Use caution when working at elevated heights and around unit openings.
Follow manufacturers’ instructions for ladders and/or scaffolding. Failure
to do so may result in injury or death.
Follow manufacturers’ instructions for hand or power tools. Always
wear safety glasses. Failure to do so may result in injury and/or
product damage.
▶Read guide from beginning to end before starting installation. Read all warnings and cautions during unit installation.
Parts Included
(1) Sash
Sash
“Andersen” and all other marks where denoted are trademarks of Andersen Corporation and its subsidiary. ©2013 Andersen Corporation. All rights reserved.
▶Check with your local building code ofcial to identify and conrm compliance with local building code requirements.
Windows and doors can be heavy. Use safe lifting
techniques and a reasonable number of people
with enough strength to lift, carry and install
window and door products to avoid injury and/or
product damage.
Sash must be supported during entire removal
and installation procedures. Failure to support
sash may result in injury and/or product
damage.
Tape broken glass with filament or duct
tape before removing sash to reduce glass
fragmentation. Failure to do so may result in
severe injury, product and or property damage.
Gently pry and remove sill stop from spline. Record location for
reapplication.
Gently pry and remove side stop from spline. Record location for
reapplication. Repeat on opposite side.
1
Interior
3
Interior
2
Interior
4
Interior
2
9069241
Gently pry and remove head stop from spline. Record location for
reapplication.
Support sash and remove sash clip screws from sash only. Save screws
for reuse.
DO NOT remove
screws securing
sash clips to
frame.
Flat Pry Bar
Spline
Side Stop
Head Stop
Spline
Sill Stop
Spline
Flat Pry Bar
Flat Pry Bar
Sash Clip Screw
Sash
Remove sash from frame using suction cup. Dispose of sash properly. Lift new sash into opening using suction cup.
7
Interior
8
Interior
3
9069241
Center sash in opening and support sash tight against sash clips. Drill
holes in sash with 3/32" drill bit 3/4 deep at sash clip locations.
Fasten sash through sash clips using saved screws.
New SashSash
Suction Cup Suction Cup
Frame
3/32" Drill Bit
Sash Clip
Sash
5
Exterior
6
Exterior
Reapply side stops by pressing kerf onto spline. Reapply sill and head stops by pressing kerf onto press t fastener spline.
9
Interior
10
Interior
4
9069241
▶Sash replacement is complete.
Sill Stop
Spline
Side Stop
Spline
/