47
USE OF THE SELECTION CONTROLS
A
. PROGRAMME SELECTOR KNOB
This control allows you to select the washing programmes. Turn
the selector so that the number or symbol of the desired
programme is opposite the reference indicator (p).
ALWAYS ROTATE the control in a clockwise direction, never in
an anticlockwise direction. Do not press the “on” button (H)
before selecting the programme
.
If you wish to modify the position of the control or select another
programme once a cycle has commenced, press the On/Off
button. Press again to recommence once the modification has
been completed.
B
. TEMPERATURE SELECTOR KNOB
THE KNOB CAN BE TURNED IN BOTH DIRECTIONS.
This control allows you to select the temperature of your wash.
If you wish to carry out a cold wash, turn the knob until the cold
symbol coincides with the selector mark.
Do not exceed the maximum temperature recommended for
each cycle in the table of programmes.
C.
SPIN SELECTOR
THE CONTROL CAN BE TURNED IN BOTH DIRECTIONS
This is one of the most important parts of the wash cycle. This
machine has a spin cycle flexible enough to meet all
requirements.Turn the selector to reduce maximum and
intermediate spin speeds. Spin can even be eliminated
altogether (setting ).
NB: THE ELECTRONICS IN THE MACHINE DISABLE THE
SPIN FUNCTION WHEN THE LOAD IS UNEVENLY
DISTRIBUTED, AND LIMIT VIBRATIONS AND NOISE
DURING WASHING.