Rev:
Part No:
Page:
E.C.O. No:
CUSTOMER SERVICE PHONE: 1-800-426-8562
1560-045 1 of 4 7029-9937
Tools Required
Wall Mounted Open Sided Wardrobe
Installation Instructions
SUITE ®
81” Height Units
with Shelf
65” Height Units
without Shelf
G
A
C
C
S-19
#2
KIT OF PARTS
H
G2
S-47
40mm Conrmat Screw
(S-19)
M4 x 25mm Screw
(S-47)
G
S-19
Rev:
Part No:
Page:
E.C.O. No:
CUSTOMER SERVICE PHONE: 1-800-426-8562
1560-045 2 of 4 7029-9937
H
H
Install back panel (G) to base shelf (H)
1
1
1
2Level and mark location of base shelf (H)
S-47
G2
40mm Conrmat Screw
(S-19)
M4 x 25mm Screw
(S-47)
Rev:
Part No:
Page:
E.C.O. No:
CUSTOMER SERVICE PHONE: 1-800-426-8562
1560-045 3 of 4 7029-9937
H
X
X - Y2 = A2
X - Y1 = A1
X - Y = A
Install base shelf (H)
1
3
Y
Y1
Y2
NOTE: Install a minimum
of 3 screws per cleat (C).
G
C
C
C
C
Specic Instructions for Wall Frame Construction
A. Wall with Wood Stud Framing or 3/4” Plywood Surfaces:
Wall cleats must be attached to either wood studs in wall or 3/4” thick plywood
securely attached to studs. Attach the wall cleats using #12 x 2-1/2” long head
screws. Use longer screws if required to securely anchor the wall cleats to the
wood studs.
B. Wall with Gypsum Board, Sheet Rock or Wall Board with Metal Stud Framing:
Wall cleats must be attached to metal studs. Use either 2” #10 sheet metal screws
or 2” #10-24 TEKS self-drilling screws.
INSTALLATION CONDITIONS
BAD: CLEAT INSTALLED TO LOW BAD: CLEAT INSTALLED TO HIGH GOOD: SHELF RESTING FULLY ON CLEAT
NOTE: Shelf is not
resting fully on cleat.
NOTE: Too much gap
between shelfs. NOTE: This is a good
install. Shelf is resting
on cleat and no visible
gap.
X - Y = A
Y
X
G
H
G
B
C
Rev:
Part No:
Page:
E.C.O. No:
CUSTOMER SERVICE PHONE: 1-800-426-8562
1560-045 4 of 4 7029-9937
Install shelf (B)
1
4
NOTE: When assembling L-Shelf (B)
refer to the “Open Sided Shelf
installation instructions”.
B
H
A A A
H
NOTE: Make sure shelf (B)
rest on cleats (C).
/
