1 of 6 6100-0020
Part No: Rev:
Page:
E.C.O. No:
CUSTOMER SERVICE PHONE: 1-800-426-8562
Tools Required
1560-045
SUITE®
Reference Shelves
Installation Instructions
#2
Upper Panel
A
Reference Shelf
C
Cleat
B
3/16” Drill
5/16” Drill
2 of 6 6100-0020
Part No: Rev:
Page:
E.C.O. No:
CUSTOMER SERVICE PHONE: 1-800-426-8562
1560-045
1Specic Instructions for Wall Frame Construction
A. Wall with Wood Stud Framing or 3/4” Plywood Surfaces:
Wall mount kits must be attached to either wood studs in wall or 3/4” thick
plywood securely attached to studs. Attach the wall mount kit using #10 x 2-1/2”
at head screws. Use longer screws if required to securely anchor the wall mount kit
to the wood studs.
B. Wall with Gypsum Board, Sheet Rock or Wall Board with Metal Stud Framing:
Wall mount kit must be attached to metal studs. Use either 2” #10 sheet metal
screws or 2” #10-24 TEKS self-drilling screws.
NOTE: Install a minimum
of 3 screws per cleat (A).
X - Z1 = A1
X - Z = A
A
A
B
BX
Z1
Z
3 of 6 6100-0020
Part No: Rev:
Page:
E.C.O. No:
CUSTOMER SERVICE PHONE: 1-800-426-8562
1560-045
2
NOTE: Install a minimum
of 3 screws per cleat (A).
X - Y4 = A2
X - Y2 = A
X - Y3 = A1
X
Y2
Y3
Y4
C
C
B
B
A
Specic Instructions for Wall Frame Construction
A. Wall with Wood Stud Framing or 3/4” Plywood Surfaces:
Wall mount kits must be attached to either wood studs in wall or 3/4” thick
plywood securely attached to studs. Attach the wall mount kit using #10 x 2-1/2”
at head screws. Use longer screws if required to securely anchor the wall mount kit
to the wood studs.
B. Wall with Gypsum Board, Sheet Rock or Wall Board with Metal Stud Framing:
Wall mount kit must be attached to metal studs. Use either 2” #10 sheet metal
screws or 2” #10-24 TEKS self-drilling screws.
4 of 6 6100-0020
Part No: Rev:
Page:
E.C.O. No:
CUSTOMER SERVICE PHONE: 1-800-426-8562
1560-045
B16" ON CENTER
MAXIMUM
X"
12" MAXIMUM
(BOTH SIDES)
B
3/16"
B
WALL CLEAT ATTACHMENT OPTIONS
FOR WOOD STUDS
WALL BOARD
B
3/4"
PLYWOOD
OR
B
S-63
NOTE: Due to varying wall
construction, fasteners are
not included and must be
feild supplied. 3/16”
Drill
#10-12 x 2-1/2" Flat Head Screw
(S-63)
5 of 6 6100-0020
Part No: Rev:
Page:
E.C.O. No:
CUSTOMER SERVICE PHONE: 1-800-426-8562
1560-045
BLOCK WALLS
FOR STEEL STUDS
Q2 16" ON CENTER
MAXIMUM
12" MAXIMUM
(BOTH SIDES)
3/4"
PLYWOOD
OR
Q2
FOR POURED CONCRETE WALLS
NOTE: Due to varying wall
construction, fasteners are
not included and must be
feild supplied.
NOTE: Due to varying wall
construction, fasteners are
not included and must be
feild supplied.
NOTE: Due to varying wall
construction, fasteners are
not included and must be
feild supplied.
3/16”
Drill
5/16”
Drill
3/16"
B
5/16"
B
S-62
#10-24 x 2" Tek Screw Self Drilling
(S-62)
1/4-20 x 4" Toggle Bolt
(S-64)
6 of 6 6100-0020
Part No: Rev:
Page:
E.C.O. No:
CUSTOMER SERVICE PHONE: 1-800-426-8562
1560-045
INSTALLATION CONDITIONS
BAD: CLEAT INSTALLED TO LOW BAD: CLEAT INSTALLED TO HIGH GOOD: SHELF RESTING FULLY ON CLEAT
NOTE: Shelf is not
resting fully on cleat.
NOTE: Too much gap
between shelfs. NOTE: This is a good
install. Shelf is resting
on cleat and no visible
gap.
A A A
/
