Haworth 6100-0022 Operating instructions

  • Hello! I'm a chat assistant that has read the SUITE 6100-0022 Overhead Storage Unit Installation Instructions. I'm ready to answer your questions about the installation process, wall mounting, door adjustments, and lock plug installation based on the provided document.
  • What screw type should I use for wood studs?
    What screw type should I use for metal studs?
    How many screws I should use per cleat?
#2
Rev:
Part No:
Page:
E.C.O. No:
CUSTOMER SERVICE PHONE: 1-800-426-8562
X1
Overhead Storage Unit
Installation Instructions
1 of 4
SUITE®
Tools Required
KIT OF PARTS
560-045 6100-0022
Overhead Storage UnitB
Wall Cleat
A
Rev:
Part No:
Page:
E.C.O. No:
CUSTOMER SERVICE PHONE: 1-800-426-8562
12 of 4560-045 6100-0022
FOR MULTIPAL SHELVES
3
NOTE: Install a minimum
of 3 screws per cleat (A).
X - Y = A
X - Y1 = A
A
B
A
X
Y
Y1
Specic Instructions for Wall Frame Construction
A. Wall with Wood Stud Framing or 3/4” Plywood Surfaces:
Wall mount kits must be attached to either wood studs in wall or 3/4” thick
plywood securely attached to studs. Attach the wall mount kit using #12 x 2-1/2”
long pan head screws. Use longer screws if required to securely anchor the wall
mount kit to the wood studs.
B. Wall with Gypsum Board, Sheet Rock or Wall Board with Metal Stud Framing:
Wall mount kit must be attached to metal studs. Use either 2” #10 sheet metal
screws or 2” #10-24 TEKS self-drilling screws.
B
NOTE: This is a good
install. Shelf is resting
on cleat and no visible
gap.
Rev:
Part No:
Page:
E.C.O. No:
CUSTOMER SERVICE PHONE: 1-800-426-8562
13 of 4560-045 6100-0022
B B
B
INSTALLATION CONDITIONS
NOTE: Too much gap
between shelfs.
BAD: CLEAT INSTALLED TO HIGH GOOD: SHELF RESTING FULLY ON CLEAT
NOTE: Shelf is not
resting fully on cleat.
BAD: CLEAT INSTALLED TO LOW
Rev:
Part No:
Page:
E.C.O. No:
CUSTOMER SERVICE PHONE: 1-800-426-8562
14 of 4560-045 6100-0022
4
3
CK-3
CK-3
HW-SERIES
X
HW-SERIES
Install lock plug (HW-SERIES)
NOTE: Position cam to
unlocked (12:00 oclock
position.
NOTE: It may be
necessary to rotate cam
until lock plug engages.
NOTE: Hold the lock
plug (HW-SERIES) in
place with thumb
while removing the
control key (CK-3).
Remove round key (CK-3)
and insert square key (X)
X
OPTIONAL LOCK PLUG INSTALLATION - HINGED DOORS ONLY
12
CK-3
AG
CK-1
HW-SERIES
Remove shipping plug
(AG) with round key (CK-1)
Replace square key (X) with round key (CK-3)
1
1
2
2
DOOR HINGE ADJUSTMENTDOOR INSTALLATION/REMOVAL - HINGED ONLY
2
1
1
2
3
1
2
3
J
J
/