2. BLOTZ
  3. B15-ME-102

BLOTZ B15-ME-102 Assembly Instructions

  • I have analyzed the provided document which serves as instructions for assembling a 15mm Desert Fort Long Wall model with gates. The document details the various stages of the build, mentioning tools, materials, and optional steps
  • What type of glue is required for assembly?
    What tool is needed to remove sections from the sprue?
    Is it necessary to glue the gates?
    Are there any optional assembly steps?
15mm Desert Fort – Long Wall - Gates
B15-ME-102
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the pieces shown above from the sprue.
Turn the “roof” upside down and attach the other
pieces to it as shown.
[Optional] Glue a door behind each doorway.
Add the front wall.
Place (do not glue) the gates into their holes.
Attach the base, slotting each lug into the
associated hole.
Add the two steps above the entrance.
The finished model.
/