Focal Point Skydome Edge Surface Mount FSDEP Installation guide

  • Hello! I've reviewed the product details for the Skydome Edge surface mount luminaires. This document provides specifications for the FSDESM-22, FSDESM-33, and FSDESM-44 models, including installation instructions, mounting locations, and safety precautions. I'm ready to answer any questions you have about these products.
  • How many people are recommended for installing the 2' and 3' models?
    How many people are recommended for installing the 4' model?
    What should be done before installation or servicing?
    Is there a specific direction for installation?
    What is the minimum clearance recommended between luminaire and wall?
IS0694 REV. A 2018 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 1 of 3
Luminaires must be installed by a qualified electrician (check with local and national codes for proper installation).
To prevent electrical shock, disconnect electrical supply before installation or servicing.
MOUNTING LOCATIONS
Skydome® Edge Surface Mount
FSDESM-22|33|44
key
pOwer Off
pOwer ON
ATTeNTION
weIGhTS:
2’ - 24.0 LbS
2 peOpLe reCOMMeNded fOr INSTALLATION
3’ - 46.0 LbS
2 peOpLe reCOMMeNded fOr INSTALLATION
4’ - 80.2 LbS
3 peOpLe reCOMMeNded fOr INSTALLATION
5.00" 5.00" 5.00" 5.00"
.77"
5.00"
5.00"
5.00"
5.00"
J-BOX ACCESS
4.55"
2.27"
7.70"
4.84"
3.47"
J-BOX ACCESS
8.10"
4.05"
12.00"
7.54"
4.25"
J-BOX ACCESS
4' DIAMETER
3' DIAMETER
2' DIAMETER
SKYDOME EDGE INSTALLS IN ONE DIRECTION ONLY
ALLOW MINIMUM 12" BETWEEN LUMINAIRE AND
WALL/OBSTRUCTION IN OPPOSITE DIRECTION
OF LUMINAIRE INSTALLATION
Contractor is responsible for adequately reinforcing walls and/or ceilings to support luminaire weight. Focal Point, LLC accepts no responsibility for inadequately reinforced walls
and/or ceilings. The information contained in this drawing is the sole property of Focal Point, LLC. Any reproduction in part or whole without the written permission of Focal Point, LLC
is prohibited.
IS0694 REV. A 2018 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 2 of 3
3
2' / 3' dIAMeTer
4' dIAMeTer
X4
X4
4
MAKE ELECTRICAL CONNECTIONS
CONNeCT MOUNTING pLATe GrOUNd wIre
TO LUMINAIre GrOUNd wIre
4' dIAMeTer
SUSPEND LUMINAIRE
USING THE LANYARDS 5
LeAve GrOUNd wIre eXpOSed fOr
eLeCTrICAL CONNeCTION (STep 4)
INSTALL CeILING pLATe TO STrUCTUre AbOve
USING 4 X 1/4”-20 bOLTS (by OTherS)
INSTALL CeILING pLATe TO STrUCTUre AbOve
USING 8 X 1/4”-20 bOLTS (by OTherS)
2' / 3' dIAMeTer
4' dIAMeTer
2' / 3' dIAMeTer
6
1prOperLy OrIeNT ANd ALIGN SkydOMe
edGe wITh MOUNTING pLATe
2
LIfT TO eNGAGe SLOTS ON reAr Of LUMINAIre wITh TeeTh ON MOUNTING pLATe.
SLIde LUMINAIre IN The dIreCTION Of The ArrOw INdICATed ON MOUNTING pLATe.
ALIGN SLOTS ON reAr Of LUMINAIre
wITh TeeTh ON MOUNTING pLATe.
2' / 3' dIAMeTer 4' dIAMeTer
7
Contractor is responsible for adequately reinforcing walls and/or ceilings to support luminaire weight. Focal Point, LLC accepts no responsibility for inadequately reinforced walls
and/or ceilings. The information contained in this drawing is the sole property of Focal Point, LLC. Any reproduction in part or whole without the written permission of Focal Point, LLC
is prohibited.
IS0694 REV. A 2018 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 3 of 3
4
DRIVER SERVICE
1 2
pULL ANd hOLd Lever TO dISeNGAGe
LOCkING MeChANISM
3
CONTINUe hOLdING Lever IN
UNLOCked pOSITION whILe
pULLING LUMINAIre IN
dIreCTION Of Lever
SUSPEND LUMINAIRE USING THE LANYARDS
5
7
CLAMp CAbLe TO SUSpeNded reAr COver
86
EMERGENCY
SEE BATTERY MANUFACTURER
INSTRUCTIONS
eMerGeNCy MAXIMUM MOUNTING heIGhT:
14.25’
/