2. Hubbell Premise Wiring
  3. HWS772049

Hubbell Premise Wiring HWS772049 Installation guide

  • I have reviewed the Hubbell instruction sheet for the Surface Mount Box HSB1xx and HSB2xx. This document provides instructions for installation, including mounting, cable routing and securing the cover. I'm ready to answer your questions about its features and installation process.
  • How do I remove the cover from the box?
    What type of raceway is compatible with the surface boxes?
    How do I mount the box to a solid surface?
    How do I secure the cover?
Control No. Page of
Rev. Date:
®Hubbell Premise Wiring Instruction Sheet
Hubbell Premise Wiring, HUBBELL INCORPORATED (Delaware)
14 Lord's Hill Rd, Stonington CT 06378 (800) 626-0005, Fax (860) 535-8328
www.hubbell-premise.com
Control No. Page of
Rev. Date:
1- and 2-PORT SURFACE MOUNT BOXES
HWS77204901 1 2
1 8/28/19
HWS77204901 2 2
1 8/28/19
This instruction sheet is applicable to the following Catalog Numbers:
Package Contents:
Installation Instructions:
1. Remove cover from box by inserting a screwdriver into the cover release slots.
See Figure 1.
1-Port HSB1xx
2-Port HSB2xx
Qty 1-Port Qty 2-Port Description
1 1 Surface Mount Box
1 2 Cable Ties, 4"
0 1 Paper Face Plate Label
0 1 Clear Plastic Label Cover
2 2 Surface Mounting Screw (6-20 x 1-1/4" self tapping)
0 1 Security Screws (6-32 x 3/4" Flat head)
1 1 Double Sided Tape, 2"
2. Surface boxes are compatible with MT6 Raceway. If using Raceway, cut the
edges of the appropriate knockout with a utility knife and remove. Align
Raceway with knockout opening. See Figure 2.
3. Mount box to solid surface with provided self tapping screws or double sided tape.
See Figure 3. Important: Maintain atness when mounting base to
mounting surface.
4. Route cables through openings in the rear of surface mount box. Using supplied
cable ties, secure cables to the strain relief anchor points. See Figure 4.
5. Terminate individual jacks and modules utilizing the supplied instructions sheets.
Insert terminated jacks or Snap-Fit modules into base unit by
securing jack between the posts under the latch.
6. Snap cover onto base unit. Secure cover with supplied security screw. See
Figure 6.
7. For 2-Port boxes only, insert face plate paper and clear plastic cover into box
identication label slots. Optionally, laser printable adhesive port labels can be
used to identify each port. See Figure 7.
Figure 7
Plastic
Cover
Face Plate
Paper
Box
Identication
Slot
Figure 4
Cable
Tie
Figure 5
Cable
Tie
Figure 6
Cover
Base
Security Screw
Figure 1 Figure 2
Cover
Raceway
knockout
Base
Figure 3
Raceway
Hubbell Premise Wiring, HUBBELL INCORPORATED (Delaware)
23 Clara Dr Mystic, CT 06355 (800) 626-0005, Fax (860) 535-8328
www.hubbell-premise.com
xx designates color
/