2. KILLARK
  3. NWP Exit Series Decals

KILLARK NWP Exit Series Decals Installation guide

  • Hello! I've reviewed the installation instructions for the Hubbell Exit Decal NWPFN/E KIL00921359. The document provides clear steps on how to apply the decal to a polycarbonate lens surface, including information on cleaning, decal application, and how to remove air bubbles. I'm ready to answer your questions about this product and its installation process.
  • What should I use to clean the lens surface?
    How do I apply the decal?
    What is the recommended method for applying the decal?
P/N KIL00921359 FORM NO. K1359 04/10 ERO-6-004-08 Side 1 of 1
HUBBELL ELECTRICAL PRODUCTS
A Division of HUBBELL INCORPORATED (Delaware)
3940 Martin Luther King Drive
St. Louis, Missouri 63113 USA
INSTALLATION INSTURCTIONS
FOR
NWPFN/E EXIT DECAL
1. Clean lens surface with a non-abrasive solution and cloth suitable for polycarbonate;
dry lens.
2. Remove adhesive liner from selected decal.
3. Apply decal to lens surface removing all air bubbles as shown below.
TYPICAL DECAL INSTALLATION
Application tip: Tape the label a the half way point (vertically) onto the surface label is to be applied to.
Peel back paper backing to tape, and cut, then smooth label onto surface, working from the center out.
Remove tape and apply other side in same manner.
DECAL OPTIONS:
/