Hubbell Premise Wiring HSE22 Installation guide

Part No. Page of

Rev. Date:

Hubbell Premise Wiring Instruction Sheet

® HWS775332 01 1 1

2 6/14/17HSE22 INSTALLATION INSTRUCTIONS

Hubbell Premise Wiring, HUBBELL INCORPORATED (Delaware)

23 Clara Dr Suite 103 Mystic, CT 06355 (800) 626-0005, Fax (860) 535-8328

www.hubbell-premise.com

HSE22 IS COMPATIBLE WITH HUBBELL HHR4510 AND HHR4516 RELAY RACKS

STEP 1

Locate the four belt loops on HSE22 into the tab slots

on HHR45xx rack.

Lower the HSE22 onto the tabs by applying

downward force until belt loops are sitting

rmly on the tab.

STEP 2

Secure the HSE22 to

the HHR45xx rack

with the two #12-

24 tamper resistant

screws. Install in the

hole located above the

upper mounting belt

loop on the HSE22.

NOTE:

When installing more

than one HSE22

enclosure to the same

side of a rack, the

lower unit must be

installed rst.

Download PDF