Intended use
The ioLiving Repeater can be used to increase the range of the LoRa radio signal. The device repeats
messages sent by measurement devices, therefore it doubles the number of LoRa signals in the operating
environment. Radio equipment requirements limit the number of LoRa signals, and the repeater is designed
to narrow down its operation when there are several (more than 10) measurement devices around it. This
must be considered when planning the location of the device since it repeats all the received LoRa
messages. There are no internal memory in the Repeater, it only transmits real time messages. The
repeaters can not be daisy-chained because the device does not repeat already repeated messages.
Deploying the ioLiving Repeater
• The device does not require any configuration.
• There can be up to four Repeaters in the vicinity of one Gateway.
• The LoRa scanner and LoRa Beacon test transmitter can be used to find the optimal location for the
Repeater.
• With the correct location of the Repeater, structures that block the radio signal can be bypassed.
• The device can be mounted on a table or wall. It can also be installed outdoors, if protected from
direct rain. The position of the device has no effect on its operation.
• The device is switched on by connecting it to the mains. Make sure that the planned location has
available power socket.
Signal light operation
• The signal light on the device indicates the operation.
• When the device is switched on, the green signal light turns on.
• The signal light turns on and off alternately when the device is repeating messages.
• If the signal light is on or off constantly for a longer time, the device may be defective or not plugged
in. This may also be due to that there is no LoRa measuring device within range of the Repeater.
The purpose of the contents of this manual is to guide the user of the device. The products it describes are subject to change without prior notice,
due to the manufacturer’s continuous development program. ioLiving Inc./Ceruus Inc. makes no representations or warranties with respect to this
manual. ioLiving Inc./Ceruus Inc. shall not be liable for any damages, losses, costs, or expenses, direct, indirect, or incidental, consequential, or
special, arising out of, or related to the use of this material or the products described herein.
