2. Razor
  3. W15110710063
W15110710063

Razor W15110710063 Operating instructions

  • Hello! I've reviewed the Razor Rear Fender W15110710063 replacement manual. This document provides step-by-step instructions on how to safely replace the rear fender of the electric scooter, including disconnecting the power and dealing with the rear light cable and wheel axle. I'm ready to answer any questions you have about the replacement procedure.
  • What tools are required for the rear fender replacement?
    What should I do before starting the replacement?
    What is the first step in the replacement procedure?
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Phillips screwdriver
B. Two (2) 19 mm wrenches
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a Phillips screwdriver, remove two (2) screws from
the battery cover on the right side of the unit.
Locate and disconnect the rear fender light from the
controller.
VECTOR REAR FENDER
REPLACEMENT PROCEDURES
PART # W15110710063
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3
Step 5
Step 4
Using two (2) 19 mm wrenches, loosen the lock nuts from
the rear axle and slide the wheel down.
Reverse the steps.
ATTENTION: Charge battery 8 hours before using.
Using a Phillips screwdriver, loosen and remove the two
(2) screws that hold the rear fender onto the frame. Slide
the cable and rear fender out from the frame.
/