Upper Handle
778-13277A© 2016 31A-3AAD
Wing Knobs
Lower Handle
B
Position the upper handle onto the lower
handle and secure with the hardware
removed in Step 1.
A. Remove the wing knob, saddle washer,
handle tab and carriage screw
from each side of the lower handle.
B. Slide one of the cable ties
from the right side
of the lower handle
up to the cross member.
A
A
Tighten the cable ties on the left side of
the lower handle and the cross member
to secure the cables in place. Trim off
any excess material of cable ties.
A push clip is included on the cable tie found
on the right side of the lower handle. If it’s not
already in place, push the clip into the hole
in the handle before tightening the cable tie
and trimming off any excess material.
1
3
2
4
READ AND UNDERSTAND ALL INSTRUCTION, WARNING, AND DANGER LABELS.
PARA INSTRUCCIONES EN ESPAÑOL, REFIÉRASE AL MANUAL DEL OPERADOR.
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY
AND FOLLOW THE IMPORTANT SAFE OPERATION PRACTICES BEFORE OPERATING .
Need Help? Call 1-888-TO-HELP-U