Focal Point ID+ 3.5" Wall Wash FLC3W / LC3 Installation guide

Type
Installation guide

This manual is also suitable for

IS0761 REV. B 2022 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 1 of 4
non-emergency - thermally protected, non-ic
id+ 3.5" round housing
FLC3D | FLC3W
Luminaires must be installed by a qualified electrician (check with local and national codes for proper installation).
To prevent electrical shock, disconnect electrical supply before installation or servicing.
LUMINAIRE MUST BE INSTALLED PRIOR TO DRYWALL CEILING.
ALL GRID LUMINAIRES MUST BE SECURED TO STRUCTURE ABOVE.
emergency - remote test switch, non-ic
Flc3d | Flc3w
Flc3d | Flc3w
key
power oFF
power on
level
attention
see additional
instructions
WALL WASH ORIENTATION
WALL
FOR ASTM E-283 AIR-TIGHT
COMPLIANCE, SEAL IC HOUSING/
RO TRIM WITH SILICONE CAULKING
BETWEEN THE EDGE OF THE COLLAR
AND CEILING MATERIAL. SEAL ALL
ADDITIONAL HOLES IN HOUSING
WITH ALUMINUM TAPE.
2.64”
.50”
.50”
3.16”
10.61”
10.61”
short cone
dns
SUPER
SHORT CONE
dss
tall cone
dnt
keep shaded area Free From oBstruction aBove ceiling
optional
Bar hangers sold separately
ic/cp
Flc3d | Flc3w
IS0761 REV. B 2022 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 2 of 4
Fixtures must be installed by a qualified electrician (check with local and national codes for proper installation).
To prevent electrical shock, disconnect electrical supply before installation or servicing.
GRID - 1/2" CONDUIT & CLIP (BY OTHERS)
X2
24x4
3
4 1/8
1
ceiling cutout
GRID - BAR HANGERS (SOLD SEPARATELY)
x2 3 4a2
4b multiple luminaires only
x4
IS0761 REV. B 2022 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 3 of 4
Fixtures must be installed by a qualified electrician (check with local and national codes for proper installation).
To prevent electrical shock, disconnect electrical supply before installation or servicing.
DRYWALL - BAR HANGERS
make electrical connections
54
METAL STUDS
x4
3
WOOD STUDS
minimum ceiling thickness: 1/2"
maximum ceiling thickness: 1-1/2"
2a x4 x4
2b
5114
adjust test switch until
canopy is Flush with ceiling BATTERY UNIT CONNECTOR INSIDE
31
0.75"
7.304"
±0.25"
Ø
4.125”
Ø
5.246
±0.58"
3.187
±0.58"
2
EMERGENCY - REMOTE TEST SWITCH ABOVE CEILING ACCESS REQUIRED
release
test switch
From Bracket
prior to
installation
6
Contractor is responsible for adequately reinforcing walls and/or ceilings to support fixture weight. Focal Point, LLC accepts no responsibility for inadequately reinforced walls and/or
ceilings. The information contained in this drawing is the sole property of Focal Point, LLC. Any reproduction in part or whole without the written permission of Focal Point, LLC
is prohibited.
IS0761 REV. B 2022 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 4 of 4
DRIVER SERVICE
1 2
EM- MOUNTING HEIGHT
SEE BATTERY MANUFACTURER
INSTRUCTIONS
emergency maximum mounting height:
downlight: 21.4'
wall wash: 16.1'
DO NOT MATE BATTERY
UNIT CONNECTOR
UNTIL INSTALLATION
IS COMPLETE AND A.C.
POWER IS SUPPLIED
SEE BATTERY
MANUFACTURER
INSTRUCTIONS
117
TO PREVENT ELECTRICAL SHOCK,
DISCONNECT ELECTRICAL SUPPLY
BEFORE SERVICING
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Focal Point ID+ 3.5" Wall Wash FLC3W / LC3 Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI