Control Panel
1. Up/Down buttons: Press the “UP/DOWN” buttons to adjust the height of the
desk. Press and hold the “UP/DOWN” buttons for more than 2 seconds to
continuously adjust the height of the desk. The screen will display “bot” when the
desktop is at its lowest point and “top” when the desktop reaches its highest point.
2. Memory buttons (1, 2, 3, 4): Press and hold the desired button for 3 seconds to
save the current desk height to the relevant key.
3. Reset: Press the “3 & 4” buttons simultaneously; the screen will display “RST”.
Continue holding the “3 & 4” buttons to factory reset the unit.
4. The desk has two USB-A ports and one USB-C port. These ports can be used to
supply power to other electronics and support charging protocol.
USB-C output: 5V3A/9V2A/12V1.5A
USB-A output: 3.6-6.5V2.4A/6.5-9V2A/12V1.5A
Tot al o u t p u t po we r of single port: 18W Max
When the desk is lifting, the output will be stopped, when the lifting stops, the
output will restart.
5. Short press the “LOCK” button to enable the child lock function to avoid accidental
adjustment and guarantee the safety of children. The screen will show “Loc” when
the desk is locked; short press the “LOCK” button again to unlock the desk.
6. Press and hold the up and down button simultaneously to adjust the sensitivity of
the anti-collision function. The anti-collision function will be disabled when the
screen shows “A-0”, and the sensitivity can be set between levels 1-3 from least to
most sensitive, with the screen showing “A-1” to “A-3” accordingly.
