Fortis Walkingpad Fordable Smart Treadmill User guide
- Category
- Treadmills
- Type
- User guide
WALKINGPAD FOLDABLE
SMART TREADMILL
(T1 PRO)
FSWKPADT1PA
Read all of the instructions in this guide before using this product. Retain this guide for
future reference. Do not skip, substitute or modify any steps or procedures in this guide, as
doing so could result in personal injury or product damage.
• Before starting any exercise program, consult your physician to determine if you have
any medical or physical conditions that could put your health and safety at risk or
prevent you from using the equipment properly. Your physician’s advice is essential if
you are taking any medication that may affect your heart rate, blood pressure or
cholesterol level.
• Incorrect or excessive exercise can damage your health. Stop exercising if you
experience any of the following symptoms: pain, tightness in your chest, irregular
heartbeat, shortness of breath, light headedness, dizziness or feelings of nausea. If you
experience any of these conditions, you should consult your physician before continuing
with your exercise program.
• Always wear comfortable properly fitting sports shoes and clothing while using the
treadmill. If you experience any discomfort while exercising stop immediately and
consult your physician.
• This equipment is intended for adult use only. Keep children and pets away from the
machine. DO NOT leave children unattended in the same room with the equipment.
Contact with the moving surface may result in severe friction burns.
• Do not get on or off the treadmill whilst it is moving as this may result in serious injury
and possible damage of the treadmill.
• When not in use, unplug the power cord.
• This appliance is designed for consumer use. Follow directions and use only as
described.
• Once fully assembled, inspect to ensure all hardware parts such as bolts, nuts and
washers are positioned correctly and tightly secured.
• Dry after each use to remove moisture. Wipe regularly with a mild, non-abrasive cleaner
and water solution.
• To ensure safety, the equipment should have at least 50 cm of free space on each side
and 200cm behind.
• Prior to assembly, ensure you have all the components.
• Always use the equipment as intended. If you find any defective components while
assembling or checking the equipment, or if you hear any unusual noises coming from
the equipment during exercise, cease use immediately and contact help.kogan.com for
assistance. Do not use until resolved.
• Do not place fingers or any other objects into moving parts of the exercise equipment.
Ensure care is taken while setting up and folding the treadmill.
• Keep hands clear of the hinges while setting up and folding the treadmill.
• Do not exceed the maximum user weight of 105KG.
• Be careful when lifting and moving the equipment. Always use proper lifting technique
and seek assistance if necessary.
• Your equipment is intended for use in cool, dry conditions. You should avoid storage in
extreme cold, hot or damp areas as this may lead to corrosion and other related
problems.
• This appliance contains no user-serviceable parts. If it suffers any failure or damage,
cease use immediately and contact help.kogan.com
• This equipment is designed and intended for indoor use only.
SAFETY & WARNINGS
• The running belt on this treadmill has a visible joint mark. This is completely normal
and will not affect the performance or operation of your treadmill.
COMPONENTS
Tr e a d m i l l
User guide
User guide
Accessories
Power
cord
Remote
control
Allen
Key
Remote
lanyard
Silicone
oil
Battery
(CR2032)
1
Belt
5
Mode button
2
Function buttons
6
Tr a n s p o r t w h e e l s
3
Display
7
Power switch
4
Folding hinge
8
Power input
OVERVIEW
1
2
3
4
5
6
7
8
Function Buttons & Display
Remote Control:
Start/Stop
Lanyard
hole
Front
Rear
Battery
cover
Mode
Speed
increase
Speed
decrease
Time
Distance
Speed
Steps
Power
Manual
mode
Automatic
mode
Error indicator
Step 1:
• Lift the rear of the treadmill until the transport wheels come into contact with the floor.
• Move the treadmill into your desired location. Avoid placing the treadmill on soft
cushions or thick carpets.
Step 2:
• Carefully unfold the treadmill, ensuring to keep your hands clear of the hinges.
• Press the rear of the treadmill down until it is completely flat.
ASSEMBLY
Step 3:
• Ensure the belt is in the centre of the treadmill and adjust if required.
Step 4:
• Connect the power cord to the treadmill power input.
• Plug the power cord into a power outlet and turn power switch to the on position.
Step 5:
• Download and install the "WalkingPad" App from App Store
(Apple) or Google Play Store (Android).
• Open the App and follow the prompts to connect to your
treadmill.
Tu r n i ng t h e t re a d m il l O n a n d O f f
• Press the Power button on the treadmill or the Mode button on the remote control to
turn the treadmill on. The display will illuminate and the treadmill will enter Manual
mode by default.
• The user can also power on the treadmill by pressing either the Manual or Automatic
buttons. The display will illuminate and the treadmill will enter the respective function.
• To t u r n o f f the treadmill press the power button on treadmill or press and hold the Mode
button on the remote control.
Speed Restriction
• The maximum speed available will be locked at 3km/h for the first 1km of usage. After
accumulating 1km of usage the maximum speed available will be 6km/h.
• Maximum speed can also be unlocked through the “WalkingPad” app by completing
the beginner guide.
Manual Mode
In Manual mode users can use the remote control to adjust the speed of the treadmill to
suit their needs. It is recommended to start with Manual mode when you are first getting
used to your treadmill.
• Speed increase button: Press the Speed increase button to raise the speed of the
treadmill by 0.5km/h.
• Speed decrease button: Press the Speed decrease button to lower the speed of the
treadmill by 0.5km/h.
• Start/Stop button: Press the Start/Stop button on the remote control to stop treadmill.
Press the button again when you are ready to resume exercising.
• Mode button: Press the Mode button on the treadmill or the remote control to switch
between Manual and Automatic mode.
OPERATION
Automatic Mode
In Automatic mode, users can adjust the speed of the treadmill without using the remote
control. Automatic mode is recommended for more advanced users of the treadmill.
• Increase speed: When the user enters the front zone of the treadmill belt the treadmill
speed will increase.
• Decrease speed: When the user enters the rear zone of the treadmill belt the treadmill
speed will decrease.
• Start/Stop button: Press the Start/Stop button on the remote control to stop treadmill.
Press the button again when you are ready to resume exercising.
• Mode button: Press the Mode button on the treadmill or the remote control to switch
between Manual and Automatic mode.
Display
Functions and Features:
• TIME: Shows your elapsed workout time in minutes and seconds
• SPEED: Displays your workout speed value in km/h.
• DISTANCE: Displays the accumulative distance travelled during your workout.
• STEPS: Displays the accumulative steps travelled during your workout.
Time
Distance
Speed
Steps
Front
zone
Rear
zone
Cleaning the Treadmill
• Disconnect the power before cleaning the treadmill.
• Add a small amount of mild detergent to a 100% cotton cloth. Do not spray the
detergent directly on the belt or use any acidic and corrosive detergents.
• Do not wipe under the walking belt
Belt Adjustment
If the treadmill belt begins to slip or is out of alignment it will need to adjusted. Press and
hold both the Mode and Speed Increase buttons on the remote control for 3 seconds. The
treadmill display will show “CALI”.
• Start the treadmill and run at a speed of 4km/h
• To a djust belt to the left, turn the left adjusting hole screw clockwise by 1/2 turn.
• To a djust belt to the right, turn the right adjusting hole screw clockwise by 1/2 turn.
• To a djust belt tension, turn the left and right adjusting screws clockwise for 1/2 turn
at the same time.
• After each adjustment, run the treadmill for approximately (1-2 minutes) to observe
if the issue has been corrected. Adjust again if necessary.
CLEANING & CARE
Belt Lubrication
• Disconnect the power before lubricating the treadmill.
• Lift the edge of the belt and apply 5-10ml of silicone oil to the inner surface. Do not
apply too much oil as this may cause the belt to slip.
• Run the treadmill at 4km/h for approximately 10-20 seconds.
• Lubricate the belt every 3 months.
Remote Control Pairing
If the remote control becomes unresponsive or if you have replaced the batteries, you will
need to re-pair the remote control by pressing and holding the mode button for 5 seconds.
Error Indicator
• E01: Communication fault
• E02: Voltage protection
• E03: IPM overheating
• E04: Low-voltage protection
• E05: Overcurrent protection
• E06: Motor protection
• E08: Sensor fault
TROUBLESHOOTING
Age range
14-60 years
Speed range
0.5-6km/h
Walking surface
1200x415mm
Max weight
105kg
Frequency
50/60Hz
Voltage
220-240V
Power Input
932W
Gross weight
30kg
Net weight
27kg
Operating size
1432x547x129mm
Folded size
822x547x129mm
Disposal
This symbol indicates that this appliance should not be disposed with other
house-hold wastes. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, recycle it responsibly to promote the
sustainable reuse of material resources.
SPECIFICATIONS
Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
Fortis Walkingpad Fordable Smart Treadmill User guide
- Category
- Treadmills
- Type
- User guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
