Thank You for choosing Rough Country for your lighting needs!!!
3. Using a 10mm socket, remove the taillight from the Jeep. See Photo 3.
4. Unplug the taillight wiring harness. See Photo 4.
4. Place the wiring harness through the rectangle hole in the license plate bracket and plug back together. See Photo
5.
5. Bolt the light housing and license plate bracket to the jeep, using the 3 supplied 6mm x 20mm bolts and washers.
Install the 2 6mm x 16mm bolts through the bracket with the bolt head towards the Jeep body. See Photo 6.
6. Tighten the light housing using a 10mm socket. Using a Phillips screwdriver, attach the taillight lens. See Photo 7.
7. Attach your license plate using the supplied 6mm x 16mm bolts, nuts and washers. See Photo 8.
By purchasing any item sold by Rough Country, LLC, the buyer expressly warrants that he/she is in compliance with all
applicable Federal, State, and Local laws and regulations regarding the purchase, ownership, and
use of the item. It shall be the buyers responsibility to comply with all Federal, State and Local laws
governing the sales of any items listed, illustrated or sold. The buyer expressly agrees to indemnify
and hold harmless Rough Country, LLC for all claims resulting directly or indirectly from the purchase,
ownership, or use of the items.
Photo 5 Photo 6
Photo 7 Photo 8
Photo 3 Photo 4