2. BLOTZ
  3. B10-CS-209

BLOTZ B10-CS-209 Assembly Instructions

  • I have reviewed the instructions for the Tower Block Foyer B10-CS-209 model. These instructions detail the steps for assembling the model using wooden pieces and glue, including the order of attaching walls, door frames, and sunscreens. I can answer your questions about the assembly process and materials required.
  • What type of glue is needed for assembly?
    What tool is needed to remove sections from the sprue?
    What can be used to hold pieces together while the glue dries?
10mm 3x3 Tower Block Foyer
B10-CS-209
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Foyer
Remove the inner front wall, its “roof” and two
door frames from the sprue.
Attach the wall to the “roof” then glue the door
frames in position as shown.
Now remove the two side walls from the sprue.
Glue the side walls to the inner front wall assembly,
aligning it using the holes/lugs provided.
Glue the outer front wall into place.
Then attach the back wall.
Glue the whole model to the base. Note there is
a “B” etched into the base which should be at the
back of the building.
Glue the door frames around the side doors and on
the back of the building.
Finally glue the sun-screens into place (etched
detail upwards).
/