2. Herman Miller
  3. Zeph Stool

Herman Miller Zeph Stool, Zeph Chair Product Instructions

  • Hello! I've reviewed the Replacement Instruction Manual for the HermanMiller Zeph 3D Knit Unibody No Arm chair. This document provides instructions on how to replace the 3D knit on your chair without the need of any tools. I'm ready to answer any questions you have about the replacement process or the chair itself.
  • What tool are required for replacement?
    How to disengage the 3D knit?
    How to open the upholstery clip?
HermanMiller ZephTM Installation Assembly Instructions1BV3ZM rev C1
Parts Included
HermanMiller
ZephTM Chair 3D Knit Unibody No Arm
Replacement Instruction Manual
How to Replace 3D Knit for ZephTM Chair
Step 2:
Open one end of the upholstery clip by pushing forward while pulling
outward to disengage hook. Then release the other end to unsnap the clip to
remove the 3D Knit.
Step 1:
Disengage the 3D knit by liing the le and right sides of the knit over the
edge of the shell, continue releasing the knit up and down the le and right
sides of the back and seat until it is fully disengaged.
3D Knit
No Tools Required
Forward
Outward
https://omnivideo.wistia.com/medias/6xjp1
Watch Installation Video below:
HermanMiller ZephTM Installation Assembly Instructions1BV3ZM rev C2
Step 3:
Detach the 3D Knit.
Step 4:
Identify seat portion of knit and apply to the seat of the shell. The sticker
identies the seat end of the knit.-
Step 6:
Push the center area around the rear edge of the seat with one hand while
snapping the clip in with the other hand into one slot shown in step 6.
Repeat for the other side.
Step 5:
Replace the 3D knit by engaging it around the top and bottom edges of the
chair, ensuring the full perimeter is engaged.
1BTGG7
5H202
1BTGG7
5H202
HermanMiller ZephTM Installation Assembly Instructions1BV3ZM rev C3
Step 7:
The New 3D knit is replaced.
/