Herman Miller Zeph Chair Product Instructions

Brand: Herman Miller

Model: Zeph Chair

Type: Product Instructions

This manual is also suitable for

Zeph Stool

HermanMiller ZephTM Installation Assembly Instructions1BV3ZR rev B1

Parts Included

HermanMiller

ZephTM Chair Tilt Assembly Replacement

Instruction Manual

How to Replace Tilt Assembly for Zeph

Chair

Step 2:

Detach the cylinder assembly.

Step 1:

Using a mallet hit both side of the chair and pull o the cylinder assembly

from the tilt assembly.

Tilt Assembly

Tools Required

Mallet Flat Screw Driver

Power Driver 5mm Hex Bit T-30 Bit

HermanMiller ZephTM Installation Assembly Instructions1BV3ZR rev B2

Step 3:

Using the flat screwdriver release snaps in the below location shown.

Step 4:

Detach the fender.

Step 5:

Open one end of the upholstery clip. Then release other end to detach from

the tilt assembly.

Step 6:

Using Trox bit remove all six 1/4-20 pan head screws using 5mm Hex bit and

M6 X 25 flat head screw using T-30 bit to detach the tilt assembly.

HermanMiller ZephTM Installation Assembly Instructions1BV3ZR rev B3

Step 8:

Replace the new tilt assembly and x it to the chair.

Step 9:

Tighten all six 1/4-20 pan head screws using 5mm Hex bit and M6 X 25 flat

head screw using T-30 bit to attach the tilt assembly.

Step 7:

Rotate the tilt assembly upward and move it out to detach from the chair.

Step 10:

Fix the upholstery clip to the tilt slot.

HermanMiller ZephTM Installation Assembly Instructions1BV3ZR rev B4

Step 11:

Attach the fender.

Step 12:

Place the back/seat assembly onto the cylinder. Sit in chair to engage tapers

(cylinder/tilt and cylinder/base).

Herman Miller Zeph Chair Product Instructions

Brand: Herman Miller

Model: Zeph Chair

Type: Product Instructions

This manual is also suitable for

Zeph Stool

Download PDF

report

Herman Miller Zeph Chair Product Instructions

This manual is also suitable for

Herman Miller Zeph Chair Product Instructions

Related papers

Other documents