2. Herman Miller
  3. Zeph Chair

Herman Miller Zeph Chair, Zeph Stool Product Instructions

  • I have reviewed the Instruction Manual for the HermanMiller Zeph Chair Upholster Clip Replacement. This document provides a step-by-step guide on how to replace the upholstery clip. It details how to disengage the 3D knit, remove the old clip without tools, and attach the new clip for the Zeph chair. I am ready to answer your questions about this process.
  • What is the first step in replacing the upholstery clip?
    How do you remove the old upholstery clip?
    Is there any special tool needed to replace the clip?
HermanMiller ZephTM Installation Assembly Instructions1BV3ZN rev A1
Parts Included
HermanMiller
ZephTM Chair Upholster Clip Replacement
Instruction Manual
How to Replace Upholster Clip for ZephTM Chair
Step 2:
Open one end of the upholstery clip. Then release other end to Unsnap the
clip to remove the 3D Knit.
Step 1:
Disengage the 3D knit by liing the ends of the knit over the edge of the
back. Repeat for the seat.
N0 Tools Required
Upholster Clip
HermanMiller ZephTM Installation Assembly Instructions1BV3ZN rev A2
Step 4:
Remove the upholstery clip.
Step 5:
Replace the new upholstery clip into the 3D knit.
Step 3:
Detach the 3D Knit.
Step 6:
Replace the 3D knit by engaging it around the top and bottom edges of the
chair.
HermanMiller ZephTM Installation Assembly Instructions1BV3ZN rev A3
Step 7:
Push the center area around the rear edge of the seat with one hand and
snap the clip in with the other hand into the slots shown in step 6.
Step 8:
The New 3D knit is replaced.
/