HermanMiller ZephTM Installation Assembly Instructions1BV3ZZ rev C1
Parts Included
HermanMiller
ZephTM Chair 3D Knit Unibody Fixed Arm
Replacement Instruction Manual
How to Replace 3D Knit for ZephTM Chair
Step 2:
Open one end of the upholstery clip by pushing forward while pulling
outward to disengage hook. Then release the other end to unsnap the clip to
remove the 3D knit.
Step 1:
Disengage the 3D knit by liing the ends of the knit over the seat. Repeat the
process for the back until it is fully disengaged.
3D Knit Fixed Arm
No Tools Required
Forward
Outward
https://omnivideo.wistia.com/medias/fu72g8948e
Watch Installation Video below:
HermanMiller ZephTM Installation Assembly Instructions1BV3ZZ rev C2
1BTGG7
5H202
Step 3:
Detach the 3D knit.
Step 4:
Identify seat portion of knit and apply to the seat of the shell. The sticker
identies the seat end of the knit.-
Step 6:
Push the center area around the rear edge of the seat with one hand while
snapping the clip in with the other hand into one slot shown in step 6.
Repeat for the other side.
Step 5:
Replace the 3D knit by engaging it around the top and bottom edges of the
chair, ensuring the full perimeter is engaged.
1BTGG7
5H202
HermanMiller ZephTM Installation Assembly Instructions1BV3ZZ rev C3
Step 7:
The new 3D knit is replaced.
-
1
-
2
-
3
Herman Miller Zeph Chair Product Instructions
- Type
- Product Instructions
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Herman Miller Zeph Chair Product Instructions
-
-
-
-
-
-
-
-
-
Other documents
-
Steelcase Think 465 User manual
-
Teknion Routes Reference guide
-
Rifton Z210 User manual
-
-
Brother KH 830 Owner's manual
-
Silver Reed F-270 Owner's manual
-
-
-
Silver Reed Knitmaster 700 Owner's manual
-
HP 15-db0000 Laptop PC User guide
