2. Oxford Garden
  3. Travira Pedestal & Post Tables

Oxford Garden Travira Pedestal & Post Tables Assembly Instructions

  • Hello! I've reviewed the assembly instructions for the Travira Pedestal & Post Tables. This document provides a step-by-step guide on how to put your new table together, including details about the components and hardware needed. I'm here to answer any questions you have about the assembly process or the features of these tables. How can I help you today?
  • What is included in the pedestal post carton?
    What is included in the base carton?
    What tools are needed for assembly?
15 Kingbrook Parkway, Suite 100 Simpsonville, KY 40067 p. 888.892.2670 f. 502.719.8888 oxfordgarden.com
ASSEMBLY INSTRUCTIONS
COMPONENTS
HARDWARE
Ver. 07.10.23
Pedestal Post
Quantity: 1
1
Table Top Assembly
Quantity: 1
Rod
Quantity: 1
3
Pedestal Base
Quantity: 1
4
Hex Head Wrench
Quantity: 1
Locking Hex Nut
Quantity: 1
B
Hex Nut
Quantity: 1
A
Flat Washer
Quantity: 1
CD
Stud
Quantity: 2
E
TRAVIRA PEDESTAL & POST TABLES
TOOLS NEEDED:
Adjustable Wrench.
NOTE:
Hex nut, locking hex nut and flat washer parts are packaged in pedestal post carton.
Studs are packaged in base carton.
NOTE: Table top, post and or base may vary from illustrations but the assembly is
the same for all Travira bar & bistro tables.
NOTE: 17” base fits 24” table tops and 32” round bistro tables.
23” base fits 32” round and square bar tables and 36” round and square bar
and bistro tables.
NOTE: Hardware pack may contain more hardware than what is needed to assemble.
For care instructions, please visit oxfordgarden.com/furniture-product-care/
Ver. 07.10.23
INSTRUCTIONS
STEP 1
Thread the hex nut onto one end of the rod about
one inch.
A
3
3
A
STEP 3
Slide pedestal post over the rod and align notches with
small plate on bottom of table as shown.
2
Detail (inside Pole)
2
STEP 2
Thread rod into table top until it touches the bottom of
the table top.
NOTE: Do not over tighten in this step. Once the rod touches
the bottom of the table top, reverse the rod one full turn.
Tighten the hex nut securely with a wrench.
1
1
STEP 4
Next, thread the studs into the base . Tighten the
studs firmly using a wrench.
Drain Hole
4
4
D
D
D
STEP 5
Next, carefully place the pedestal base over the post
making sure to line up the studs with the holes in the plate
as shown.
2
4
STEP 6
Insert flat washer and locking hex nut over the rod
and secure tightly using an adjustable wrench.
C
B
CB
/