Oxford Garden Travira 34” X 48” Rectangular Bistro Table Assembly Instructions

Type
Assembly Instructions
15 Kingbrook Parkway, Suite 100 Simpsonville, KY 40067 p. 877.866.3331 f. 502.719.8888 oxfordgarden.com
Ver. 06.30.20
TRAVIRA 34” X 48” RECTANGULAR BISTRO TABLE
ASSEMBLY INSTRUCTIONS
COMPONENTS
HARDWARE
NOTES
Table top, post and or base may vary from illustrations but the assembly is the same for all
Travira 34” x 48” Rectangular Bistro Tables
Hex Nut
Quantity: 2
A
Locking Hex Nut
Quantity: 2
B
Flat Washer
Quantity: 2
C
Lock Washer
Quantity: 2
D
Table Top Assembly
Quantity: 1
Two Pedestal Post
Quantity: 1
Rod
Quantity: 2
Pedestal Post Foot
Quantity: 2
Ver. 06.30.20
INSTRUCTIONS
STEP 1
Thread one of the hex nuts onto one end of rod
about one inch. Repeat for both rods.
STEP 2 -
Thread rods into table top snuggly until you feel it hit
the table top. NOTE: Do not over tighten in this step.
Once you feel the rod is snug, reverse the rod about one
half a turn. Tighten hex nut securely with wrench.
Ver. 2019.8.10
STEP 3
Slide pedestal post over the rod and align notches with
small plate on bottom of table as shown.
STEP 3 (detail)
STEP 4
Next, place pedestal post feet over threaded rod as
shown.
1
2
STEP 5
Insert flat washer , lock washer and locking hex nut
over the rod and secure tightly using wrench.
3
1
A
2
3
A
Detail (inside pole)
4
4
CDB
C
B
D
  • Page 1 1
  • Page 2 2

Oxford Garden Travira 34” X 48” Rectangular Bistro Table Assembly Instructions

Type
Assembly Instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI