Page is loading ...
1/4"
1/4"
Drill
Tools Required
1/4"
C
D
A
A
Rev:
Part No:
Page:
E.C.O. No:
CUSTOMER SERVICE PHONE: 1-800-426-8562
1350-108
XSERIES®
Workstation Locker
Installation Instructions
1 of 2 7029-9893
#2
1-1/2" MAX.
B
A
SHELF BRACKETS (C) INSTALLATION/REMOVAL
LEVEL LOCKER (A)
SHELF (D) INSTALLATION/REMOVAL
1
1
2
2
Workstation Locker
18”
12”
#10 Hex Nut
(H3)
#10-32 x 3/4" Screw
(H1)
#10 Flat Washer
(H2)
WARNING! Appropriate
screws/bolts must be used to
attach locker (A) to wall. Due
to various wall constructions,
fasteners are not provided.
NOTE: The 12” lockers MUST
be anchored and/or ganged
together.
18” OR 24”
G
G
DOOR HINGE ADJUSTMENTDOOR INSTALLATION/REMOVAL
2
1
1
2
3
1
2
3
FOR 12” LOCKERS ONLY: ANCHOR & GANGING
4
3
CK-3 CK-3
HW-SERIES
X
HW-SERIES
Install lock plug (HW-SERIES)
NOTE: Position cam to
unlocked (12:00 o’clock
position.
NOTE: It may be
necessary to rotate cam
until lock plug engages.
NOTE: Hold the lock
plug (HW-SERIES) in
place with thumb
while removing the
control key (CK-3).
Remove round key (CK-3)
and insert square key (X)
X
OPTIONAL LOCK PLUG INSTALLATION
12
CK-3
AG
CK-1
HW-SERIES
Remove shipping plug
(AG) with round key (CK-1)
Replace square key (X) with round key (CK-3)
1
1
2
2
Rev:
Part No:
Page:
E.C.O. No:
CUSTOMER SERVICE PHONE: 1-800-426-8562
1350-108 2 of 2 7029-9893
12”
NOTE: Anchoring may be done
through the side or back of le.
Anchoring should be done as
close to the corners of the le as
posible.
WARNING! Appropriate screws/bolts
must be used to attach locker (A) to wall.
Due to various wall constructions,
fasteners are not provided.
NOTE: Use the hardware provided
in locker.
NOTE: Use drop cloth to catch
metal shavings when drilling.
1-1/4” to 4” 1/4"
Drill
H3
A
H2
H1
OR
1
2
EE
DOOR PUSH LATCH (E) ADJUSTMENT
3
F
/
