2. Haworth
  3. 7021-8213b

Haworth 7021-8213b Operating instructions

  • Hello! I have reviewed the installation instructions for the SERIES K / PROFILE / TRIPOLI 3 CLUSTER BASE Conference Tables. This document provides detailed steps on assembling the table, including attaching stretchers, sub-tops, and table tops. I'm ready to assist you with any questions you have about these instructions.
  • What tool is needed for installation?
    What is the correct orientation for the dado ring?
    What type of screws are used?
100#
Part No: Rev:
Page:
E.C.O. No: 305-009 1 O F 2 7021-8213 B
CUSTOMER SERVICE PHONE: 1-800-426-8562
Tools Required
SERIES K/ PROFILE/ TRIPOLI
3 CLUSTER BASE
CONFERENCE TABLES
Installation Instructions
CBY3
CBY4
Part of
Joint
Fastener
C
A
K
W ooden
B is c u it J o in e r
Table Top
Assem bly
Sub-Top
L
EStretcher
J
H
Glide
In s e rt
D
G
F
C
Part of
Joint
Fastener
3 C luster
Base
B
#8 x 1.50" Flat Head Screw
(L )
#8 x 1.50" Pan Head Screw
(D )
#8 x 3/4" Flat Head Screw
(J )
#2
Leveler
Pad
Wooden
Biscuit Joiner
(B )
M
100#
Weight
100#
NOTE!
Dado ring must face
downward for
cluster bases.
Part No: Rev:
Page:
E.C.O. No: 305-009 2 O F 2 7021-8213 B
CUSTOMER SERVICE PHONE: 1-800-426-8562
2In s ta ll s tr e tc h e r in s e rts (H )
1In s ta ll s tr e tc h e r s (E )
#8 x 3/4" Flat Head Screw
(J )
3Add w eights and align sub top (K ) 4
NOTE!
Repeat step for other base.
If necessary install tops (A ) together
G
H
H
F
E
J
G
3 C luster
Base
E
G
K
A
NOTE!
Repeat step for other end.
5
#8 x 1.50" Pan Head Screw
(D )
Dado ring must
face downward
for cluster bases.
Align flat brackets
with dado ring.
100#
#8 x 1.50" Flat Head Screw
(L )
KL
M
NOTE!
100#
In s ta ll to p (A ) a n d le v e l ta b le
G
A
A
C
B
C
NOTE!
Place tops on a carpeted or padded
surface. Refer to 7021-6905 for
installation of Joint Connector (C).
/