BLOTZ B28-VSF-006 Assembly Instructions

Brand
BLOTZ
Model
B28-VSF-006
Type
Assembly Instructions

This manual is also suitable for

Onaga Rocket Kohaya
B28-VSF-006
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Take the sides, struts and support plates (shown
above) from the sprue.
Stick the support plates to the reverse side of a side
piece as shown above. The arrow should point
towards the front of the ship.
The same pieces shown from the other side –
showing the position of the notch.
Attach the other side piece and slide the support
struts into place.
Take the main deck and “wall” from the sprue.
Attach the deck using the holes / lugs provided.
Glue the “wall” into position. Allow to dry.
Take the base plate and prow sections from the
sprue.
Turn the model over and attach the base plate as
shown above.
Glue the prow pieces into place.
Take the middle and upepr deck sections plus the
top “wall”….
..and glue them into position.
Take the pieces shown above from the sprue.
Attach them to the model as shown, with etched
detail facing outwards.
Take the two angled supports.
Glue them into place.
Then take the two side stern plates…
..and attach one on each side of the model.
Take the stern pieces.
And glue them into place.
Each rocket is formed from the pieces shown
above.
Start by glueing the internal supports together.
Place the largest ring over the supports, aligning
the flat portions of the inner ring with the
supports. Repeat for the other rings.
The sides of the rocket are formed from these
pieces.
Glue the semi-circles into the central space as
shown.
The axle is made from these pieces.
Glue them together as shown.
The rear plate plus the two rockets.
Glued together as above.
All the pieces of the rocket section.
Place the axle through the holes in the sides, then
attach the sides to the rear plate as shown above.
Glue the rest of the pieces into place.
The washers…
Place three on each end of the axle.
Each front sail is formed from the pieces shown
above.
Glue the main sections back to back, then attach
the support brackets.
Glue the two outer “clips” into position.
The two completed front sails.
The rear sails are formed from these pieces.
As with the front sails, glue the ain pieces back to
back then attach the supports – note these slope
down towards to the front of the sail.
Glue the brackets into place.
The ships wheel is formed from these three pieces.
Glue them together as shown.
Attach the ships wheel to the hole in the middle
deck, then glue the door frames and ladders into
place.
Attach the front and rear sales, aligning their lugs
with the holes in the hull plates.
Gently flex the rocket support struts and insert the
rocket section. You may need to glue this to help
hold it in position.
The completed model.
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

BLOTZ B28-VSF-006 Assembly Instructions

Brand
BLOTZ
Model
B28-VSF-006
Type
Assembly Instructions
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents