Page is loading ...
Installation
The following illustration is showing the fully installed system.
CAMERA (BNC)
TIME LAPS VCR
PTZ
ALARM
INTERNET
COMPUTER
Audio Input
(
Micro
p
hone
)
.
CH1 CH2 CH3 CH4
VIDEO INPUT
AUDIO INPUT
VCR OUT MONITOR OUT
ETHERNET
1234
RS-485
AUDIOVIDEOAUDIOVIDEO
GND
TRIGGER OUT
RS232
+
-
CAMERA(6 PIN MINI DIN)
CAMERA
This product can be installed up to 4 cameras.
Connect the provided cameras (6 Pin Din) to the VIDEO IN on the back panel of the
product.
To connect a PTZ camera, connect the PTZ camera’s control line to the RS-485 (+, -)
terminal and connect the video output to one out of VIDEO IN on the back panel of the
product.
CH1 CH2 CH3 CH4
VIDEO INPUT
AUDIO INPUT
VCR OUT MONITOR OUT
ETHERNET
1234
RS-485
AUDIOVIDEOAUDIOVIDEO
GND
TRIGGER OUT
RS232
+
-
BNC CAMERA
PTZ
ALARM
6 PIN MINI DIN
CAMERA
AUDIO
The system includes two indoor cameras built-in Audio and two outdoor camera (without Audio)
built-in IR LEDs (Infrared) to view objects in the darkness. Install two indoor cameras to any
channel and select one of the corresponding channel with A-SEL button on the front panel to
record the audio along with video signal or communicate with others where the camera is
installed (Press the TALK button to communicate). Normally this system is in listening mode.
If the camera (BNC) does not have an Audio function, connect the proper audio device
(microphone) to the AUDIO IN (1 Vp-p @600 ohms) and speaker to the AUDIO OUTPUT
CAMERA (BNC)
TIME LAPS VCR
Microphone
CH1 CH2 CH3 CH4
VIDEO INPUT
AUDIO INPUT
VCR OUT MONITOR OUT
ETHERNET
1234
RS-485
AUDIOVIDEOAUDIOVIDEO
GND
TRIGGER OUT
RS232
+
-
CAMERA
(6 PIN MINI DIN)
Monitor
There are two video outputs (BNC) on the rear panel of this system. Connect monitors,
Time Lapse VCR for backup on the tape and etc. depending on your application.
TIME LAPS VCR
CH1 CH2 CH3 CH4
VIDEO INPUT
AUDIO INPUT
VCR OUT MONITOR OUT
ETHERNET
1234
RS-485
AUDIOVIDEOAUDIOVIDEO
GND
TRIGGER OUT
RS232
+
-
/
