Clover CSM-1414Q Installation guide

Type
Installation guide
How to Install
Back of Monitor
1 2 3 4 5 6 7 8
1. CAMERA 1 TERMINAL - Connect camera 1 cable ( BNC ) to this terminal
2. CAMERA 2 TERMINAL - Connect camera 2 cable ( BNC ) to this terminal
3. CAMERA 3 TERMINAL – Connect camera 3 cable ( BNC ) to this terminal
4. CAMERA 4 TERMINAL – Connect camera 4 cable ( BNC ) to this terminal
5. CAMERA 5 TERMINAL – Connect camera 5 cable ( DIN ) to this terminal
6. CAMERA 6 TERMINAL – Connect camera 6 cable ( DIN ) to this terminal
7. CAMERA 7 TERMINAL – Connect camera 7 cable ( DIN ) to this terminal
8. CAMERA 8 TERMINAL – Connect camera 8 cable ( DIN ) to this terminal
Note: BNC cable not included
Audio /video Jack Connections
Refer to the following connection method when connecting this monitor to a standard VCR
( use RCA cables , not supplied )
Monitor
(VCR Input/ Output)
VCR Terminal
Video OUT Video IN
Audio OUT Audio IN
Video IN Video OUT
Audio IN Audio OUT
The VCR must be programmed or selected in one of the following modes: Video 1,
Video 2, AUX, A/V or
LINE IN mode for recording ( refer to the Owner’s Manual of the VCR for input
selection procedure). If
this programming is not completed, the recorded images may be distorted.
Refer to the following connection method when connecting this monitor to a time
lapse recorder
( use RCA cables , not supplied )
Monitor (VCR Input/ Output)
Time Lapse Recorder
Video OUT Video IN
Audio OUT Audio IN
Video IN Video OUT
Audio IN Audio OUT
Refer to the following connection method when connecting a slave monitor
( use RCA cables , not supplied )
Master Monitor Slave Monitor
Video OUT Video IN
Audio OUT Audio IN
Note: The maximum length of RCA cable (not supplied) that you can use from the
monitor to the VCR, or from monitor to monitor is 20 meters.
  • Page 1 1
  • Page 2 2

Clover CSM-1414Q Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI