Whirlpool AKR 439 NB Program Chart

Brand: Whirlpool

Model: AKR 439 NB

Type: Program Chart

This manual is also suitable for

5019 318 33120



AKR 419-420-421-424-425-426-427-428-429-430-439

AKR 440-601-619-620-624-625-626-627-628-629-720

INSTALLATIONSANGABEN

Mindestabstand zur Kochfläche: 60 cm (Elektrokochplatten), 70 cm (Gas-, Öl- oder

Kohlekochplatten). Folgen Sie bei der Installation der Nummerierung (1

.....).

Schließen Sie das Gerät erst nach erfolgter Installation an die Stromversorgung an.

INSTALLATION SHEET

Minimum height above cooker: 60 cm (electric cookers), 70 cm (gas, gas oil or coal

cookers). To install, follow points (1

.....). Do not connect the appliance to the

electrical power supply until installation is completed.

FICHE D'INSTALLATION

Distance minimale par rapport à la cuisinière : 60 cm (cuisinière électrique), 70 cm

(cuisinière à gaz, mazout ou charbon). Pour le montage, suivez la numérotation

.....). Ne branchez pas l'appareil tant que l'installation n'est pas terminée.

INSTALLATIEKAART

Minimumafstand tot het kooktoestel: 60 cm (elektrische kooktoestellen), 70 cm

(kooktoestellen op gas, olie of kolen). Volg voor de montage de nummering

.....). Geef het apparaat geen stroom totdat de installatie geheel voltooid is.

FICHA DE INSTALACIÓN

Distancia mínima desde los quemadores: 60 cm (quemadores eléctricos), 70 cm

(quemadores de gas, gasóleo o carbón). Para el montaje, siga la numeración

...). No conecte el aparato a la corriente eléctrica hasta que la instalación

esté completamente finalizada.

FICHA DE INSTALAÇÃO

Distância mínima dos fogões: 60 cm (fogões eléctricos), 70 cm (fogões a gás, óleo ou

carbono). Para a montagem siga a numeração (1

.....). Não ligue o aparelho à

corrente eléctrica até a instalação estar concluída.

SCHEDA INSTALLAZIONE

Distanza minima dai fuochi: 60 cm (fuochi elettrici), 70 cm (fuochi a gas, gasolio o

carbone). Per il montaggio seguire la numerazione (1

.....). Non dare corrente

all’apparecchio finché l’installazione non è totalmente completata.

ùüùü+ùùùþ

ü$12.)12.1.)2"0120" FP02!"0120" FP0120".0! #

02!0. #0! # +.22  21.  #120 2.!1







2! 3 / 2020002!)!0*.21#10#!2   !&1

2"0.212.1"

31833120.fm Page 1 Monday, March 8, 2004 4:20 PM

5019 318 33120



AKR 419-420-421-424-425-426-427-428-429-430-439

AKR 440-601-619-620-624-625-626-627-628-629-720

31833120.fm Page 2 Monday, March 8, 2004 4:20 PM

5019 318 33120



AKR 419-420-421-424-425-426-427-428-429-430-439

AKR 440-601-619-620-624-625-626-627-628-629-720

1. Control panel.

2. Grease filters/grease filter grid.

3. Lighting unit (not present in AKR 427-440-627-720).

4. Pull-out steam deflector.

5. Halogen bulbs (AKR 427-440-627-720 only).

Removing and renewing or cleaning the

grease filter:

1. Disconnect the electrical power supply.

2. Pull out the steam deflector (Fig.1,a).

3. Open the extractor grille (Fig.1,b-c-d) or remove the

grease filter (Fig. 1, m1-m2).

4. Remove the device securing the grease filter (Fig. 2,e or

Fig. 3,e).

5. Remove the dirty grease filter.

6. After the grease filter has been replaced or cleaned

(depending on model), refit the parts in reverse order,

making sure the entire extraction surface is covered.

Fitting or renewing the carbon filter:

1. Disconnect the electrical power supply.

2. Pull out the steam deflector.

3. Open the extractor grille or remove the grease filter.

4. If the carbon filter is already fitted and needs renewing,

press the release buttons

(Fig. 4,h) and pull the filter out downwards.

5. If the filters are not already fitted (Fig. 4).

f. Locate the carbon filter on the back rings.

g. Secure the filter in front with the clips (h) supplied

with it.

6. Refit the extractor grille or grease filter.

Replacing bulbs

1. Disconnect the electrical power supply.

2. Pull out the steam deflector.

3. Open the extractor grille or remove the grease filter.

4. Remove the burnt-out bulb. Use 40 W max E14 bulbs,

20 W max GU5.3 halogen bulbs (models AKR 427-440-

627-720 only) or 9 W PL bulbs only (models AKR 419-

426-619-626 only).

5. Refit the extractor grille or grease filter.

CONTROL PANEL

(Switches or Buttons)

Light Switch/Button

The switch/button has two positions).

To switch on the lights: move the switch to the right

(model with switches) or press the button (model with

buttons).

Extraction speed selection Switch/Buttons

There are different extraction speed settings,

depending on the amount of steam and fumes.

To increase the extraction speed: move the switch, or

next button to the right.

Halogen bulbs

Fig. 1

AKR 439-440

Fig. 2

Fig. 3

Fig. 4

PRODUCT SHEET

F NL E PGBD I

31833120.fm Page 4 Monday, March 8, 2004 4:20 PM

Whirlpool AKR 439 NB Program Chart

Brand: Whirlpool

Model: AKR 439 NB

Type: Program Chart

This manual is also suitable for

Download PDF

report

Whirlpool AKR 439 NB Program Chart

This manual is also suitable for

Whirlpool AKR 439 NB Program Chart

Related papers

Other documents