Whirlpool AKR 439 AV Program Chart

Type
Program Chart

This manual is also suitable for

5019 318 33120
AKR 419-420-421-424-425-426-427-428-429-430-439
AKR 440-601-619-620-624-625-626-627-628-629-720
INSTALLATIONSANGABEN
Mindestabstand zur Kochfläche: 60 cm (Elektrokochplatten), 70 cm (Gas-, Öl- oder
Kohlekochplatten). Folgen Sie bei der Installation der Nummerierung (1
Ö
2
Ö
3
Ö
.....).
Schließen Sie das Gerät erst nach erfolgter Installation an die Stromversorgung an.
INSTALLATION SHEET
Minimum height above cooker: 60 cm (electric cookers), 70 cm (gas, gas oil or coal
cookers). To install, follow points (1
Ö
2
Ö
3
Ö
.....). Do not connect the appliance to the
electrical power supply until installation is completed.
FICHE D'INSTALLATION
Distance minimale par rapport à la cuisinière : 60 cm (cuisinière électrique), 70 cm
(cuisinière à gaz, mazout ou charbon). Pour le montage, suivez la numérotation
(1
Ö
2
Ö
3
Ö
.....). Ne branchez pas l'appareil tant que l'installation n'est pas terminée.
INSTALLATIEKAART
Minimumafstand tot het kooktoestel: 60 cm (elektrische kooktoestellen), 70 cm
(kooktoestellen op gas, olie of kolen). Volg voor de montage de nummering
(1
Ö
2
Ö
3
Ö
.....). Geef het apparaat geen stroom totdat de installatie geheel voltooid is.
FICHA DE INSTALACIÓN
Distancia mínima desde los quemadores: 60 cm (quemadores eléctricos), 70 cm
(quemadores de gas, gasóleo o carbón). Para el montaje, siga la numeración
(1
Ö
2
Ö
3
Ö
...). No conecte el aparato a la corriente eléctrica hasta que la instalación
esté completamente finalizada.
FICHA DE INSTALAÇÃO
Distância mínima dos fogões: 60 cm (fogões eléctricos), 70 cm (fogões a gás, óleo ou
carbono). Para a montagem siga a numeração (1
Ö
2
Ö
3
Ö
.....). Não ligue o aparelho à
corrente eléctrica até a instalação estar concluída.
SCHEDA INSTALLAZIONE
Distanza minima dai fuochi: 60 cm (fuochi elettrici), 70 cm (fuochi a gas, gasolio o
carbone). Per il montaggio seguire la numerazione (1
Ö
2
Ö
3
Ö
.....). Non dare corrente
all’apparecchio finché l’installazione non è totalmente completata.
ùüùü+ùùùþ
ü$12.)12.1.)2"0120" FP02!"0120" FP0120".0! #
02!0. #0! # +.22  21.  #120 2.!1

Ö
Ö
Ö
2! 3 / 2020002!)!0*.21#10#!2   !&1
2"0.212.1"
D
GB
F
NL
E
P
I
GR
31833120.fm Page 1 Monday, March 8, 2004 4:20 PM
5019 318 33120
AKR 419-420-421-424-425-426-427-428-429-430-439
AKR 440-601-619-620-624-625-626-627-628-629-720
31833120.fm Page 2 Monday, March 8, 2004 4:20 PM
5019 318 33120
AKR 419-420-421-424-425-426-427-428-429-430-439
AKR 440-601-619-620-624-625-626-627-628-629-720
GR
1. Control panel.
2. Grease filters/grease filter grid.
3. Lighting unit (not present in AKR 427-440-627-720).
4. Pull-out steam deflector.
5. Halogen bulbs (AKR 427-440-627-720 only).
Removing and renewing or cleaning the
grease filter:
1. Disconnect the electrical power supply.
2. Pull out the steam deflector (Fig.1,a).
3. Open the extractor grille (Fig.1,b-c-d) or remove the
grease filter (Fig. 1, m1-m2).
4. Remove the device securing the grease filter (Fig. 2,e or
Fig. 3,e).
5. Remove the dirty grease filter.
6. After the grease filter has been replaced or cleaned
(depending on model), refit the parts in reverse order,
making sure the entire extraction surface is covered.
Fitting or renewing the carbon filter:
1. Disconnect the electrical power supply.
2. Pull out the steam deflector.
3. Open the extractor grille or remove the grease filter.
4. If the carbon filter is already fitted and needs renewing,
press the release buttons
(Fig. 4,h) and pull the filter out downwards.
5. If the filters are not already fitted (Fig. 4).
f. Locate the carbon filter on the back rings.
g. Secure the filter in front with the clips (h) supplied
with it.
6. Refit the extractor grille or grease filter.
Replacing bulbs
1. Disconnect the electrical power supply.
2. Pull out the steam deflector.
3. Open the extractor grille or remove the grease filter.
4. Remove the burnt-out bulb. Use 40 W max E14 bulbs,
20 W max GU5.3 halogen bulbs (models AKR 427-440-
627-720 only) or 9 W PL bulbs only (models AKR 419-
426-619-626 only).
5. Refit the extractor grille or grease filter.
CONTROL PANEL
(Switches or Buttons)
Light Switch/Button
The switch/button has two positions).
To switch on the lights: move the switch to the right
(model with switches) or press the button (model with
buttons).
Extraction speed selection Switch/Buttons
There are different extraction speed settings,
depending on the amount of steam and fumes.
To increase the extraction speed: move the switch, or
next button to the right.
Halogen bulbs
Fig. 1
AKR 439-440
Fig. 2
Fig. 3
Fig. 4
PRODUCT SHEET
F NL E PGBD I
31833120.fm Page 4 Monday, March 8, 2004 4:20 PM
  • Page 1 1
  • Page 2 2
  • Page 3 3

Whirlpool AKR 439 AV Program Chart

Type
Program Chart
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI