BLOTZ B28-ME-002 Assembly Instructions

28mm Middle Eastern Building #2

B28-ME-002

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and

remember to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while

you allow glue to dry.

Remove the pieces shown above from the sprue.

Glue the centre wall between the two longer walls

to form an “H” shape as shown above.

Attach the two end walls – Note the notches in

them face towards the front of the model.

Glue this assembly to the base.

Take the rear wall of the compound and the short

wall of the small building.

Glue these into position as shown.

Next take the side wall of the compound and the

front wall of the small building.

Add these to your model.

Add the front wall of the compound.

[Optional] Glue the two doors into position.

Add the archway pieces to the front and rear of the

entrance.

The roof supports.

Glue these into place as shown, ensurin that no

glue is on their top face.

[Optional] Glue the trapdoors onto the roof pieces.

Place (no not glue) the roof pieces in position.

The finished model.

Download PDF