Ampire LDS-CDR31-CP Installation guide

Ampire
Brand
Ampire
Model
LDS-CDR31-CP
Type
Installation guide
O F F / O N
O F F / O N
O F F / O N
O F F / O N
O F F / O N
O F F / O N
O F F / O N
O F F / O N
10A
FPC排线
Porsche(Bose CDR3.1-2010~2016) WIRING DIAGRAM---LDS-CDR31-CP
Connect to CARPLAY-USB cable
WIFI ANTENNA Multimedia USB RGB input cable
Upgrade Optional cable
Connect to the Phone's original cable
Connect to original headunit
Connect to RGB output device Connect to the original
safety box's ACC
RED---12V output for rear view camera
ORANGE--Reverse control cable for AVM /without reversing gridline
YELLOW---RCA Front/Rear video input(Connect to front /rear view camera
/360 AVM/DVR
stereo audio cable
Microphone cable Microphone
Touch Cable
Connect to the original cable of the
original headunit
AUX Connector
Pls plug it into the original
AUX IN port LCD OUT cable LCD_OUT
DIP SWITCH SETTING
(After changing the dip code,press "reset"or power-on again)
PIN 1
PIN 2
PIN 3
PIN 4
PIN 5
PIN 6
PIN 7
PIN 8
NG / Bose CDR31system
NG / Touch point coordinate correction,and then turn "OFF"
Close front view camera/Open front view camera
Reversing gridline/Enable 360 panoramic
NG / NG
Rear view camera CVBS input / RGB input
NG / NG
After market rear view camera/Original rear view camera
O N
O F F
Reset Dip Switch LED
1) Separate the removed host and the panel, stick the protective tape at the
position shown in the figure, and open the 30PIN wiring and 4PIN touch
wiring of the display 2) Take out the FPC cable as shown and
install it as required to avoid short circuit 3) Cover the FPC cable with tape and install the original panel,
then connect the FPC extension cable to the adapter plate as
shown in the picture above
FPC cable
FPC extension cable
  • Page 1 1

Ampire LDS-CDR31-CP Installation guide

Ampire
Brand
Ampire
Model
LDS-CDR31-CP
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents