2. Digital Monitoring Products
  3. SecuritySensorTM Carbon Monoxide

Digital Monitoring Products SecuritySensorTM Carbon Monoxide Quick start guide

  • Hello! I'm here to assist you with your SecuritySensor Carbon Monoxide detector. I've reviewed the user guide, which covers installation, testing, and placement. I am ready to answer your questions about the device and its proper use. Let me know what you would like to learn about your CO detector.
  • Where should I place the CO detector?
    How do I remove the CO detector from its base?
    How do I test the CO detector?
SecuritySensor™ Carbon Monoxide
Once you have logged into your Virtual Keypad App™
and plugged in your keypad, use this guide to install
your carbon monoxide (CO) detector.
PLACE THE CO DETECTOR
CONTINUE TO THE NEXT SENSOR
Continue installing the rest of your sensors, then select the Continue
button on the Virtual Keypad App™ to add a user code and complete
the installation.
1
2
QUICK START GUIDE
LT-1528 16325
HAVE QUESTIONS?
See your SecurityGateway™ System User Guide
or contact your security system provider.
MOUNTING
SCREW
MOUNTING
SCREW
TEST
BUTTON
Place your CO detector on a ceiling in the center of a room, or on a wall 4-12
inches below the ceiling. If possible, place it in a hallway near bedrooms.
1. Twist the CO detector to remove it from its mounting base.
2. Use the two provided screws and anchors to mount the base.
3. Press the test button. The green LED turns o and the red LED turns
on continuously.
4. Reattach the detector to the base by lining up the tab on the lip of
the detector with the slot on the lip of the mounting base and rotat-
ing until it clicks into place.
TAB
SLOT
/