2. BLOTZ
  3. B15-ACC-004

BLOTZ B15-ACC-004 Assembly Instructions

  • Hello! I have reviewed the instructions for the BLOTZ Bus Shelter B15-ACC-004. This document contains detailed steps for the assembly of the model, including the attachment of walls, roof sections, and seats. It also details tool and material requirements. I'm here to answer your questions about its construction.
  • What glue is recommended for assembly?
    What tool is required to remove parts?
    What can be used to hold pieces in place while glue dries?
15mm Bus Shelters
B15-ACC-004
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
The body of each shelter is formed from the
pieces shown above.
Attach the seat to the back wall – on either side
depending if you want the advertising boards on the
inside or outside of the shelter.
Attach the two end walls.
Add a wide roof piece (see above)
Then add the thin roof section of the centr eof
the roof, followed by a second wide roof piece.
/