2. BLOTZ
  3. B10_MC_004

BLOTZ B10_MC_004, B10-MC-004 Assembly Instructions

  • Hello! I have analyzed the instructions for assembling the BLOTZ vehicle shelters B10-MC-004. This document outlines the steps, from removing the parts from the sprue, to gluing the walls and supports together, and finally assembling the upper pieces. The instructions advise on necessary tools and offer additional tips for a seamless build. I'm ready to answer any questions you may have about the assembly process or other details in this document.
  • What kind of glue is required?
    What tools are needed?
    How should pieces be held while glue dries?
Vehicle Shelters
B10-MC-004
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue.
Please use knives with due care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the three supports and two side walls from
the sprue.
Glue the side walls to the supports as shown above.
Take three of the upper pieces and starting with the
central one, glue them into position.
Then glue the rest into place.
The completed vehicle shelters
/