Infinite Peripherals Infinea X IX-I2DBTR-PH5-WH Quick start guide

Type
Quick start guide
QUICK START GUIDE
*Also available in black
INFINEA
®
X
1
2
3
6
5
4
9
4
8
1
2
3
4
5
67
FRONT SPEAKER
iOS ON/OFF BUTTON
SCAN BUTTON
STATUS LEDs
SPEAKER TOGGLE BUTTON
1.
2.
3.
4.
5.
MICROPHONE
HOME BUTTON
BATTERY STATUS BUTTON
VOLUME BUTTONS
6.
7.
8.
9.
iOS CAMERA OPENING
BARCODE SCANNER
RFID ANTENNA
BATTERY PACK
BATTERY LATCH
1.
2.
3.
4.
5.
REAR SPEAKER6.
ABOUT YOUR INFINEA X
ASSEMBLY
Secure the cover by inserting
(6) torx screws. Do not over
tighten screws.
3
Close the top cover, being careful
not to pinch the wires, while
maintaining the position of the
protective rubber bumper.
2
1
Open the Infinea X by loosening the
torx screws and gently flipping open
the top cover. Slide the iOS product
onto the Lightning
Connector and
audio jack until it clicks into place.
CAUTION: Please take care that the rubber bumper is properly aligned between the top and bottom covers. Failure to do so will compromise the liquid protection
features of the Infinea X. If you have any questions about installation of the rubber bumper, please contact your sales representative.
Lightning™ Connector
Audio Jack
iOS device will not sync to iTunes
Infinea X is not configured for sync.
Swipe gestures not detected by iOS device
Top cover is not properly installed.
Audio playback not heard from front speakers
iOS device is not connected to audio jack.
Innea X front speaker cable is damaged or
disconnected.
Audio playback not heard from rear speakers
iOS device is not connected to audio jack.
Rear speaker not powered.
iOS device does not charge
AC adapter may not meet charging
requirements
Pass Through Sync is enabled.
Integrating the Infinea X into your iOS
application requires the use of the Infinite
Peripherals mobile device SDK. For the latest
Infinite Peripherals mobile device SDK, please
visit our developer portal ipcmobile.com/
developer.
TROUBLESHOOTING
1. Attach the charging cup to the bottom
of the Infinea X.
2. Plug the USB end into an AC wall
Adapter.
Note:
The AC adapter must support at least 2.1
amps
.
CHARGING
BATTERY STATUS
The Infinea X portable barcode scanner is
designed specifically for use with iPod Touch®/
iPhone® by allowing the iPod and iPhone to
sync with iTunes® through the Infinea X while
connected.
1. Ensure that Pass Through Sync option is
enabled in the SDK.
2. Connect the Infinea X to a computer using
the Charging Cup.
SYNCING
ACCESSORIES
Please visit our Accessories page at
ipcmobile.com, or contact your Infinite
Peripherals sales representative for more
information about available chargers and
battery packs for the
Infinea X.
100% - 75%
74% - 50%
49% - 25%
24% - 10%
9% - 1%
LEDs solid green
LEDs blink green
LEDs blink orange
LEDs blink red
One LED blinks red/
emergency low battery
Press the battery status button to view LEDs.
QSG-10000 Rev
. D
Mobility Sales/Technical Center
Innite Peripherals, Inc.
17681 Mitchell N
Irvine, CA 92614
Toll-Free: (866) 278-7860
Oce: (949) 222-0300
Headquarters/Main Warehouse
Innite Peripherals, Inc.
2312 Touhy Ave.
Elk Grove Village, IL 60004
Toll-Free: (800) 278-7860
Oce: (847) 818-1260
Fax: (847) 818-1287
Specications subject to change without notice. Innite Peripherals,
Mobilize Your Enterprise, Linea Pro, Innea, Innea Tab and Innea
Omni are trademarks of Innite Peripherals, Inc. All other trademarks
are the property of their respective owners.
Technical Support
Innite Peripherals, Inc.
17681 Mitchell N
Irvine, CA 92614
Toll-Free: (866) 278-7860
Oce: (949) 222-0300
Email
Website
ipcmobile
.com
Part Numbers: IX-I2DBTR-PH5-WH, IX-I2DBTR-PH5-BK,
IX-I2DBTR-POD5-BK, IX-I2DBTR-POD5-WH
WARRANTY
Innite Peripherals does not warrant, and is not
responsible for, any damage to the Innea X (“Product”)
or the assembled iOS product as a result of liquid or solid
particle intrusion into the Product or damage caused by
dropping the Product with the assembled iOS device.
If a material or workmanship defect arises with regard
to any Innite Peripherals product, and a valid claim is
received within the Warranty Period, Innite Peripherals
(at its sole discretion) will (1) repair the Product using
new or refurbished parts or (2) replace the Product
with a new or refurbished Product. For purposes of
this limited warranty, refurbished” means a product or
part that has been substantially returned to its original
specications. In the event of a defect, these are your
exclusive remedies.
PRODUCT RETURNS
Use the link provided to create an account and
gain access to our Knowledge Base and online
support services. Through our online support
center, you’ll be able to download files, open a
Support Ticket, manage your RMAs, view your
account Profile and subscribe to Alerts.
To Request a RMA:
1. Create a user account in the RMA
Support Portal at ipcmobile.com/
support/rma/
2. Login to your user account and click
Create RMA Request.
3. Read the instructions provided and
complete the online request form.
4. Note the assigned RMA number and
write it clearly on your shipping carton.
5. Ship your equipment back to us at the
address provided.
  • Page 1 1
  • Page 2 2

Infinite Peripherals Infinea X IX-I2DBTR-PH5-WH Quick start guide

Type
Quick start guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI