VIEWPOINT RUNNING BOARD
2019-2022 TOYOTA RAV4
www.tacautoparts.com Page 2 of 8 6/24/19 (AL)
8. Move to the Passenger/Right Front mounting location. Select (1) 8mm Bolt Plate. Insert the Bolt Plate
into the hole in the outer rocker panel, (Figure 12A). Slide (1) 8mm Plastic Retainer onto the threads of
the bolt plate to hold the bolt in position, (Figure 12B).
9. Select (1) 10mm L-Shapped Bolt, (Figure 12C). Insert the L-Shapped Bolt into the hole in the inner
floor panel. Slide (1) 10mm Plastic Retainer on the threads of the bolt plate to hold the bolt in place,
(Figure 12B).
10. Select the Passenger/Right Front Mounting Bracket.
a. For the 10mm L-Shaped Bolt. Attach the bracket to the L-Shaped Bolt with (1) Locking Plate, (1)
10mm Flat Washer, (1) 10mm Lock Washer and (1) 10mm Hex Nut.
b. For the 8mm Bolt Plate. Attach the bracket to the bolt plate with (1) 8mm Flat Washer, (1) 8mm
Lock Washer and (1) 8mm Hex Nut, (Figures 13—15). Do not tighten hardware at this time.
11. Move to the Passenger/Right Center mounting location, (Figure 1). Select the Passenger/Right Center
Mounting Bracket. Repeat Steps 8—10 to attach the bracket to the panels, (Figures 16 & 17).
12. Move to the Passenger/Right Rear mounting location, (Figures 1 & 18). Insert (2) 8mm Bolt Plates into
the outer hole in the outer rocker panel and the inner hole in the inner floor panel. Slide (2) Plastic
Retainers to hold the bolt plate in place, (Figures 12A & 19). Select the Passenger/Right Rear
Mounting Bracket. Attach the bracket to the Bolt Plates with (2) 8mm Flat Washers, (2) 8mm Lock
Washers and (2) 8mm Hex Nuts, (Figures 20 & 21).
13. Select and carefully unwrap the Passenger/Right Running Board. Insert (6) 6mm T-Bolts in to the
channels on the bottom of the Running Board, (Figure 22). Attach the Running Board to the mounting
brackets with (6) 6mm Flat Washers, (6) 6mm Lock Washers and (6) 6mm Hex Nuts, (Figure 23).
14. Repeat Steps 2—13 for the Driver/Left Running Board installation, (Figures 24—26).
15. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment, Do not use any type of polish or wax that may contain abrasives that could damage the
finish. For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild soap
may be used also to clean the Running Board. Mild soap may be used to clean the Running Board.
(Fig 1) Passenger/Right Rocker Panel and Floor Panel pictured
Front
Outer panel
Inner Panel
