S P E C F I L E
ET-PKF110H
Ceiling mount bracket for high ceilings
As of July 2011
SFL11A003-1
1 / 1
Weights and dimensions shown are approximate. Specifications subject to change without notice.
194
∅49
∅42
(1-15/16)
70
Projector
Attachement
plate
369–449
(14-17/32–17-11/16 )
Adjustable in
20 mm (25/32) steps
Adjustable in
20 mm (25/32) steps
65 (2-9/16 )
(2-3/4)
(1-21/32)
(7-5/8)
175
(6-7/8)
430 (16-15/16)
13 (1/2)*
3-∅ 9.5 (∅
3/8)
∅8.5 (∅ 11/ 3 2 )
20 (2-9/16)
150 (5-29/32)
424–504
(16-11/16–19-27/32)
160 (6-5/16)
140 (5-1/2)
110 (4-11/32)
130 ( 5-1/8)
100 (3-15/16)
From center of
rotation to center
of lens
*
5
°
2
0
°
10
°
1
0
°
Specifications
Vertical correction angle: +5°, -20°
Horizontal slant correction angle: ±10°
Horizontal turn correction angle: ±5°
Dimensions (W × H × D): 313 × 309–389 × 222 mm
(12-5/16˝ × 12-5/32˝–15-5/16˝ × 8-3/4˝)
Weight: Approx. 2.3 kg* (5.1 lbs*)
Attachment plateIllustration shows the bracket attached to a projector.
Parts
Attachment plate . . . . . . . . . . . . . . . . . . . . . . . . 1
Projector mount bracket . . . . . . . . . . . . . . . . . . . 1
Adjuster pole A . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Adjuster pole B . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Angle adjuster A . . . . . . . . . . . . . . . . . . . . . . . . . 1
Angle adjuster B . . . . . . . . . . . . . . . . . . . . . . . . . 1
Washer-fitted hexagonal bolts (M6 × 12) . . . . . 19
Washer-fitted screws (M4 × 10) . . . . . . . . . . . . . 4
Wire rope for projector mount bracket . . . . . . . . 1
Wire rope for projector unit . . . . . . . . . . . . . . . . 1
*
A
verage value. May differ depending on models.
unit : mm (inch)
NOTE: This illustration is not drawn to scale.
Dimensions
Description
This ceiling mount bracket is used when mounting a PT-FW430 series or other Panasonic projector to high ceilings.
C a u t i o n :
• Mounting should be done by a qualified technician.
• Make sure that the mounting (ceiling) area has sufficient strength.
• Read the enclosed mounting instructions thoroughly before starting.
• Do not use an electric screwdriver or impact driver to tighten screws. Use a torque driver or hexagon torque
wrench and tighten screws to the torque specified in the instructions.
• When the product is no longer going to be used, have it disposed of quickly by a professional disposal service.
/
