Page is loading ...
S P E C F I L E
Ceiling mount bracket for low ceilings
SFD10A016
ET-PKD110S
As of October 2010 1 / 1
DLP and the DLP logo are trademarks of Texas Instruments.
Weights and dimensions shown are approximate. Specifications subject to change without notice.
Attachment
plate
Attachment
plate
Projector
35 (1-3/8)
70
(2-3/4)
208.5
(8-7/32)
276
(10-7/8)
20 (25/32)
65
(2-9/16)
65
(2-9/16)
173.5
(6-27/32)
95 (3-3/4)
125 (4-29/32)
145 (5-23/32)
37 (1-15/32)
130 (5-1/8)
160 (6-5/16)
8.5
(11/32)
2-3-R5
(2-3-R3/16)
Specifications
Vertical correction angle: +5°, -15°
Horizontal slant correction angle: ±10°
Horizontal turn correction angle: ±3°
Dimensions (W × H × D): 219 × 83 × 282 mm
(8-5/8˝ × 3-9/32˝ × 11-3/32˝)
Weight: Approx. 1.5 kg* (3.3 lbs*)
Attachment plateIllustration shows the bracket attached to a projector.
Parts
Attachment plate . . . . . . . . . . . . . . . . . . . . . . . . 1
Projector mount bracket . . . . . . . . . . . . . . . . . . . 1
Angle adjuster . . . . . . . . . . . . . . . . . . . . . . . . . . . 1
Washer-fitted bolts (M6 × 12) . . . . . . . . . . . . . . . 8
Washer-fitted bolts (M4 × 12) . . . . . . . . . . . . . . . 4
*
A
verage value. May differ depending on models.
unit : mm (inch)
NOTE: This illustration is not drawn to scale.
Dimensions
Description
This ceiling mount bracket is used when mounting a PT-DZ570 series DLP
™
projector to low ceilings.
C a u t i o n :
• Mounting should be done by a qualified technician.
• Make sure that the mounting (ceiling) area has sufficient strength.
• Read the enclosed mounting instructions thoroughly before starting.
• Do not use an electric screwdriver or impact driver to tighten screws. Use a torque driver or hexagon torque
wrench and tighten screws to the torque specified in the instructions.
• When the product is no longer going to be used, have it disposed of quickly by a professional disposal service.
/